Honda Spree and Elite 50 Forums

after clearning carb again and running seafoam in with the gas started good but when i gave it gas it wont stay running after reading some posts i found something to try i removed the bystarter and put finger over the hole and it ran good could this be the problem after it warms up ? i put 12 volts ...

where can i find out how to decarbonized cylaner head or ecaust port

the idle sounds normal cleaned carb again removed every screw blew air in all ports same thing. what is seafoam and where do i find it, also i will have to do hame work to find out how to decarbonized cylaner head or ecaust port is this what is sounds like?

ok i removed all hoses to carb also removed tank cleaned replaced filter starts then when i give it gas no go

i replaced spark plug runs good until i give it gas then bogs right down carb is cleaned now wat ? comp is good help please

I HAVE A 1997 SA 50 PA IT WONT STAY RUNNING WHEN I TRY TO GIVE IT GAS IT STALLS I TOOK CARB OFF CLEANED PUT BACK TOGETHER SAME THING REMOVED THE EXHAUST STILL WONT STAY RUNNING HELP!!!!!!!!!!

its like a choke it is on the carb,

thanks it was th bystarter thanks for all the help running great!!!!!!!!

A bystarter is like an automatic choke. I hooks onto the side of the carb.

great job all it was the bystartes thanks again for the help :D

great job all it was the bystartes thanks again for the help :D

where in michigan(detroit ) can i find a bystarter for a nq50 in the detroit area thanks

thanks

plug ok carb setting ok the bystarter wont move it just gets warm. bad?

i took of the bystartes hooked up 12 volts to it and it gets a little hot but needle wont move how do i tell if this is bad or not i put a ohm meter and it read about 3 ohms it should be no more then 10 ohms help thanks