Honda Spree and Elite 50 Forums

Hi all,
I was wondering if it is possible to put an af16e engine from a 98 elite on an 89 sb50 frame. If so how do I do it?
Thanks

Ok so how would I go about fixing/diagnosing this?
Thanks

This morning I started up my 98 elite sa50p and is seemed to be idling very low. When i would stop at a stop light I would have to keep giving it gas or it would stall out. When I got home and put it on the stand however, it started to accelerate very quickly. So basically when the wheel is on the g...

Yeah tell me about it. Ill just have to keep my eyes open for a used one.
Thanks

Do you know if a flywheel from a 1990 sa50 elite will fit on my 98 sa50p elite?
Thanks

I have a 98 elite. Im pretty sure the crankshaft is fine though so ill just have to find a new flywheel...

I bought a torque wrench, torqued it correctly, and the woodruff key sheared once again. I think that the flywheel is what is causing the problem, the slot where the key slips into is worn down/stripped.

Ok so I'm gonna rent a torque wrench from the auto zone loan a tool, but do you know of anything I can rent to keep it from spinning when I torque?
Thanks

Alright so how do I make sure it is torqued properly?
Do I just need to tighten it with a torque wrench or do I need some special tool?... I have gone through two woodruff keys already. So how do I tell if it is installed correctly?
Thanks

How do you properly put in the woodruff key?

I can see how it goes in but I have already installed one and it broke. Are there any tricks to know that it is on correctly?
Thanks

How do I know if it was converted to a larger ZX rear pulley?

I have a 98 SA50P and my drive belt broke. The part number is 23100-GG2-7500 HONDA-BANDO. The problem is I cannot find this belt anywhere. Is it the same as the 23100-GG2-751? I bought it already modded, so I do not know if the stock belt will work or not...
Thanks

I recently took out my oil pump and replaced it with an oil pump plug. I want to sell my oil pump but I am not sure if it works, since the guy who I bought the scooter from had been running premix and not even using the oil pump because of a big bore installation. Before I took it out I ran the scoo...

sounds about right

I was out riding on my elite yesterday and the drive face seems to have completely stripped my crankshaft. I was wondering what would cause this to happen, I dont wanna put a new crank shaft in there to have this happen again. Also if you guys have a crankshaft for a 98 sa50p elite that you wanna se...