Honda Spree and Elite 50 Forums

Thanks everyone for the help. I just removed the crank completely! I had to make some brackets to get the steering wheel puller to mount the tranny cover. Next on my list is purchasing a bearing remover tool. When the time comes to re install the crank into the cases, do i press the bearings onto th...

Thanks everyone for the help. I just removed the crank completely! I had to make some brackets to get the steering wheel puller to mount the tranny cover. Next on my list is purchasing a bearing remover tool.

Thanks everybody, my steering wheel pullers doesn't look like it will do the job on the tranny side so I might have to modify it. Thanks for the bearing separator tool info as well, that would be my next question.

Thank you, that side is off. I need to remove the transmission side so the crankshaft is completely removed.

This is where I'm at... I need to get the transmission side out of the block. http://i1263.photobucket.com/albums/ii628/laplantebd/Elite%20project/2012-06-15_20-29-00_528.jpg This side!! http://i1263.photobucket.com/albums/ii628/laplantebd/Elite%20project/2012-06-15_20-29-13_758.jpg Thanks for your ...

I never heard of a chicker foot , what if i throw a socket over the shaft and hit the hammer on that?

Hello, i searched wiki but it wasnt very clear. I split the case on my 87 se50p. How do i remove the crank? (hit with a hammer???) I need to clean debris out of the crankcase.

Thank you!

Here is my daily, a 2011 Yamaha C3 i picked up new in february. 4 stroke liquid cooled. Its a lot of fun!

I looked thru wiki but couldn't find anything on the crank. I guess I'll be ordering one of those tusk tools for reassembly.

Thanks! I just split the case. How do I get the crank out? (hit it with a hammer???) I'm guessing its pressed on the tranny side bearing. While its apart should I get new bearings?

Thanks!

Thanks, right now im working on removing the flywheel. Its stuck pretty good. I will be splitting the cases to check for debris. I wont be removing much from the ports, just enough to smooth em out. What dremel bit should i use?

Thanks much!

I love the build, where did you get your MTB stem and bars? I checked fleabay and they look pretty expensive.

Thanks!

Pics!!!

Thanks for the info, geezer! I might have to get the dremel out this weekend!

Thanks much! I have a few updates, stripped er' down to the frame and started disassembly of the engine. I have decided to keep it bare framed with just pegs or something for my feet, time will tell. I have to find a new front fork. As of now I guess I'm just planning on taking the engine completely...