Honda Spree and Elite 50 Forums

Got it local. Been running my mhr bore for 6yrs now and recently with the yasuni on it kinda wore down its compression. it's gonna need a new piston and rings soon

No prob on my bore kit but my crank I had one where splines did not line up with drive face anyone had that issue. I'll get a product number up later

Yeah lost it a few times, even looking at photos I tend to get throat sore. My routine has completely changed since then as I leave and come back from work my friend isn't there since I always tie her up,no walks no barks,bath/feed play time nothing. But one thing I do hate is when people say it's j...

Sorry for the loss just lost my pit may19 after 12yrs of Having Her. Was always by my side when I was wrenching and photo bombing my pix

If I had my 8.4 gearing that would put me in 11k but my mhr wasn't making good power there, 10k range is the happy place anything in the 11s was more like reving than moving and just using more gas. Next build will be the polini corsa and I think this should match the pipe better but will see haven'...

It is a jjh needle and the clip is one below the middle so I have to go back to the stock needle that came with the polini 24pwk which has a thinner tapper "richer" so I'll either be in the middle or second from the top and maybe even go lower on main since I still didn't even break 350 on...

Ended with a 112 main any lower would lower my speeds to 70's Temps actually stayed cool only backing off the throttle at wot would raise my temps so I brought the needle up to help cool of the 1/4-3/4.

Last day and the results were 71mph moving onto the next build
Wasn't worth dropping from 8.4 to 7.8 for an extra 2mph with lower rpms

I'm @10800-11000

It's funny cause even on a downhill it just flattens always at 69. One day I spent 4 hours tunning and the results were the same only deference was lower or higher max rpms. Also tried various pulleys polini,malossi,keli,Daytona with no luck but I did notice the polini gave the best acceleration and...

Oh yeah its a fully built motor malossi crank,stage 6 reeds,malossi cdi everything you can think of. On my old setup on my scorpion I could do 74@11800 with 8.44 gearing without all these goodies

Yeah if I put the s trans I would be in the 75 but I love the torque the zx puts out

specs were

mhr bore,ct black w/24 polini carb 42pilot 126main jjh needle 2nd from top,malossi pulley 33grams,zx trans w/malossi torque driver 7.8 gears

Ok this is for the people that have purchased the c16. What are your top speeds/results of this pipe so far. I'm at a point it can't go any faster than 69mph and that was with a zx trans and 7.8 gearing mhr bore thought it would help if I lowered it from 8.44 but it didnt. Just wanna see if I can do...