Honda Spree and Elite 50 Forums

Anyone have information as to what these scooters are worth or what they've sold for in the past ??

Would 86 Spree fuel sending unit work in my Gyro NN5O gas tank?

SLA=3D printing?? no I'm not, but you probably could make OEM Copy of cap, printing with ABS plastic, great way to resurrect discontinued parts!

Thanks.I had no idea how OEM part was made.Since dirt and grease comes out under cover,I think your idea, making a sealed cap is probably the most rational choice.What a pathetic existence I lead. I am a 70 year Noob obsessing over 10 square inches of red plastic !!

ramped tab?? my tabs weren't ramped ? rather snugly fit into notches.there's still time to ramp tabs?

I'm also fixing cracks and missing parts of fender edges.I'll be painting engine cover tomorrow with Krylon Fusion 2328 red pepper
lucky to find such a close match for red NN50 plastic off the shelf

without seeing OEM part,I made a notched piece that fits flush in the opening.I'll cut a cover piece like yours and epoxy it to the notched part. Hopefully I will wind up with a functional cap, which will be removable.Do you think this is the way the original was?How did you get the nice curve on yo...

I'm trying to replicate it.I think I know how it's shaped, but Don't know for sure..

I'm trying to replicate missing small panel on my red gyro.Any one have photos or details??

Has any one used 3d printing for small scooter parts??

suprasNsprees, thanks for your straight forward reply!

mousewheels, thanks for your link to NN50 manual.I recently purchased two Honda gyros and look forward to getting and sharing info with members.

thanks for your most informative reply/

I have an 84 Gyro NN50 need sparkplug and gap info.Thanks

sanjuro wrote:Geez I want one of those so bad.

I've got a red gyro, 400 miles on speedometer. runs good. wasilly