Honda Spree and Elite 50 Forums

wow i just installed a az24 belt and it works great , my scooter has a 68cc big bore kit and the belt works perfect

well they are almost to bear metal, ive seen on ebay a complete scooter clutch with dimentions for $25 , it says that its used in a 4 stroke but if the dimenssions match then could i use it on my two stroke spree??

hello, i have two honda sprees, they both have 68cc bore kits and they run beautiful, one got just over 3k and the others got just under 3k miles. Every other part of the bottom end is all origanal as far as i know, and i would like to replace the clutch shoes but i dont know how or where to get the...

well i dont understand, i thought the scooter doesnt have gear its cvt? i did put a bore kit and itshould be performing better than stock , i have rode agins 3 differnt spree all stock and they seem to be faster around 5-8 mph fasster

Alright so no rollers , then can someone tell a basic way to get better acceleration and a little more top end with out spending ALOT ??

I did not get the gear set , it could be the belt considering that it has never been replaced , but how about new
Rollers and springs. Can I even do that?

Hello, Im debating wether I should get a high output ignition coil and cdi for my spree that has a big bore kit. Im not sure if it will screww up my engine ????

hello, i have a 86 spree and recently installed a big bore kit 68cc , i broke it in properly and will only go 26mph on flat and around 32 down hill reving the engine high . It has alot torqe but no speed and im pretty sure a stock spree goes atleast 32 on a flat, im not sure why it so slow???

Well I purchased it not running And it came with a bore kit so that was installed and it ran great but then this happened, win he head off it still does this , so Im going to tear it aprt when I get the new gaskets and bearing, when it's apart I will be able to see. I had gotten two and they came wi...

Yes I think its probably the crank bearings , I think I will just buy the bearing, because there not to expensive .


Thank you

So does anyone know what it could be , it's in the bottom end

I'm sorry but I don't know much but what do u mean by the rest pin clip, I have both of the wrist pin clips if that was what u were trying say .

Thank you

Hello, I have a 86 Honda spree, I jut put a brand new big bore kit on it around 70cc , anyway I got it running and starting perfect, then one day I go to start it and it locks up , so I turn the flywheel win my hand and it turns a little bit and then gets harder and harder to turn until it just stop...

yep now it works great

I put the fuel fuel petcock from my other spree on the one that was not running , a couple of seconds later the spree started and ran good, all I have to do is break in the new big bore kit.

Thank you