Honda Spree and Elite 50 Forums

So
it looks VERY much like this chinese one
same little crome mouth
a little more retro in the back end, but almost the same
i will be playing with it tomorrow, so will take pictures

can anyone give me info about these ?
anything we should watch for ?
it hasn't been started in at least a year

not sure yet
we are hoping to get into it and pull some panels off soon
no keys makes it hard to get into it right now
how can we pop the seat without a key ?

OK A Test of your scooter skills :) A friends of mine just got given a Scooter, no key or papers, so of course we don't know what it is (It may have papers in the storage we can't open) It looks like a Jazz in shape, but has a crome "mouth" on the front of it in about the same place as his...

so, i pulled the carb apart a few times this weekend, still playing with it
came to the realization that the scooter has no reed valves
and i am missing a spring in the idle screw
just thinking of a rebuild or another

what would be the recomendation for jets ?
the main and the slow ?

and it's starting to look more and more like it's the clutch it gets a hot burnt clutch smell if i punch it off the line it's a bit better if i baby it, but still starts to act funny at the 10-15 minute mark i have the whole clutch and bell housing on order as well, so i'll put in the new spring int...

thank you
it sounds like i should be ok using a dio spring
i have one on order, it's heavier than stock
we'll see how it works

thanks folks !

what weight would i need ?
what would going heavier or lighter acheve ?

would an Aero 50cc work the same ??

I'll measure it up this weekend

and should i just get the spring ?
or the whole cluth assembly ?

and to add to my stupidity, if i'm looking for it on ebay, what would it be called ??

could i just stretch it out for now until i can get the new spring ?

honestly, not yet
i have to find one
i will see what i can find right now and get it ordered
after we played with it before, everything seemed so good, that i didn't even think about it !

i have lighter than stock weights, should i be looking at a different tension than stock ?

is that 'cold start' feature something in the carb ?
I have the Carb from a CR80 dirtbike on it (there when i bought it)

I will pull my carb apart again and see if i can clean it up more

Thanks

not that i can tell
it has a manual choke on the carb, and no oil injection, i pre-mix
the only hose going to the carb is for gas, even that hose has nothing but a shut-off on it, not even a filter !
that's something else i need to deal with.....

Hello again you guys are always so helpful hope you can help again I have an 1983 NH80 (aero) I have been trying to make it happy for a few weeks now it runs great when cold, lots of pick up once it starts to warm up (about ten minutes) it gets REALLY bogged down so bad it stalls or tries to Let it ...

so i did the rollers, did touch the belt or plug thought i would only change one thing at a time to see if i could figure out which thing did it i know it was recommended that i go with 15's for weight all i had access to was 12 and 14.5's i am going to go with all heavier i think, but i wanted to s...

the rollers are so flat on some sides you can almost see the metal i will swap them out, and see if that is any better, also look at greasing the pins in the rear i'm putting a new belt on as well, just in case we'll see how that helps or not, and i'm sure i'll be back again tomorrow with news thank...

rarely does it go below that
coldest ever her -10 Celcius, wouldn't be riding if that was the case
so i would think the 6 should be ok then
thanks
i'll work on the other stuff suggested and be back with more questions i'm sure !