Honda Spree and Elite 50 Forums

We'll now I have an amazing loo liking Polini kit I hope I can fine motor shrouds asap I WANA RIDE

I've been trying I have I phone 4 and if won't let me upload pics says to many kig

I rebuild motors all the time just not proformance motors I no about rings and pistons the kit. I got from chop chop was * up believe me I did it all right the cylinder was egg shaped almost the rings and piston weren't the right size. I new they weren't wen I was putting it together but I figured t...

Graphite. It did come with mains and I only ran 1/4 tank 16 to one premix in it I don't have oil pump At that time I had stock carb with 102 jet. I siezed motor because the cylinder was honed hoe ably and rings were way to loose the exhaust port ate the ring off first time I half throttled it I woul...

On the corsa does the ports on piston go toward exaughst or rear wheel

Nvm I no how to install cht I wasn't thinking. Wat temp should I be trying to get. With my set up

And it didn't come wit pilots. But the main is way longer than a normal main jet I haven't taken bowl off to see wats in it

Wat exactly is a plug. Chop and how do u instal thermostat

I no there is no radiator I am useing the fan instead of the shrouds

72cc Polini corsa,v8 muffler, 24mm oko carb (reed and intake came with), eBay special variator, 9to 1 gear set, eBay special cdi, no plastics on enging or anywere else. Haven't installed head yet scared to over heat. Do u think it will can I get a couple tips to make run great Jet size? I have 115-1...

Most helpfull answer I've receive on this during yet thank u.

Can I just take the shaft out Clean with degreaser. And fill hole with epoxy then use saw zawto cut all the bull s*** off top of pump. Or does the oil pump plug have to. Go down all the way. I don't understand y the ones they sell have the smooth shaft with no teeth what the point of going all the w...

Does the kit I orders come with a piston barring

There both ugly as s*** it's a moped The only good thing it Hondas are the best made moped there is. But the elites will go faster if you take out a few restrictions that are very simple. Exaughst "washer" , variator plate and cdi

I orderd it grim scooter swAp shop And no I had the bolts in the right holes I've just taken it apart and tightend it all back so many times