Honda Spree and Elite 50 Forums

Thanks vintage, I had it backwards and that solved the problem. Still trying to figure out exactly how i want them mounted but threw this together tonight in about 30 minutes. Gotta say im pretty impressed with the gauges so far, picked up temp gauge and about 8 feet of the cht wire for $16 and tach...

Yes it is the sport cast. My main might not be that high, I really can't remember it's been like a month since I changed em out. I tried going lower on idle but had problems with it idling though I think I had an air leak then that believe is fixed now. I read a lot of stories of people burning up t...

I haven't touched weights or springs, all stock cept for belt carb and bbk. I've been holding off carb tuning until I get my temp gauge sorted but last I remember idle is 45 and main is like 110. I know main is little high and been thinking I should probably move needle one notch to lean. I just got...

wow Melo cant believe it was just the spark plug. I pulled the old plug and this time it was nasty looking. Ran a compression test and came out at 90 "little low"? but it started right up and cruised great down the road getting up to 40. Ill keep an eye on it and take it easy, been dying d...

I got some new plugs ordered and should be in tomorrow morning. Ill have to wait to tear anything down til weekend, they are re-paving parking spots so bike is out on the street and can't really work on it.

I've had the bbk on for quite while now and put about 400+ miles on so far, runs great but I know its little rich and still need to tweek the carb. Anyways I go to my college orientation Monday night and on the way home about half a mile I lose all power, it bogs really hard and sputters. I limp it ...

Have a tach and temp gauge im installing that will be wired to scooter battery, looking for advice on best place to wire into for accessory on power. Should I wire into the ignition? I think the green is acc hot and black/white is acc neutral? or is there someplace else that is preferred? Thanks Per...

Awesome thanks vintage didn't notice that before

Looking for 01 elite 50 coil, what other years/models use the same coil?

I gave it another shot but i seem to be missing something and not sure what. I put the gear back on just like in this picture from the wiki but it still doesnt seem right. I ended up just removing the little cap on the right for now and back to using the electric start so i could test drive the new ...

Ok bones you were spot on, pulled the cover and in fact i did tighten it onto the belt, the drive pulley wasnt completely in. Removed the belt re-tightened everything correctly..If I electric start with the cover off..holding the starting gear in place so it doesnt move and hit the drive face everyt...

Just installed new polini belt and 9:1 gears and noticed this noise when I rev. Is this something to be concerned about or noise to be expected with changes made? https://youtu.be/QkiwXBOvKug You should remove the kicker cover and inspect before running it again. You may have tightened the front pu...

Whinning gears?

Ok, ill take it apart and look at it. Not sure what could be causing it, i only took drive pulley off and right.back on for new belt. Took clutch off and right back on after I put in new gears. The polini belt I bought does says it's a performance belt and wider than stock, would that cause the sound?

Just installed new polini belt and 9:1 gears and noticed this noise when I rev. Is this something to be concerned about or noise to be expected with changes made?

https://youtu.be/QkiwXBOvKug