Honda Spree and Elite 50 Forums

Ok so after it sitting in the garage all winter I finally figured it out. The wires to the coil were swapped with the wires to the oil level sender. I had checked them about a hundred times and verified them as correct as the manual has them as green when I realized the the ones on the oil level sen...

Thank you so much!

without would be better but I'd bet the dimensions are the same for both with the only difference being the signal indicators

Does anyone know or is willing to measure the dimensions of their luggage rack? My 87 spree came without one and I can't find one anywhere so I want to attempt to weld one up and would greatly appreciate some accurate dimensions to get it right.

Thanks!

Does anyone know or is willing to measure the dimensions of their luggage rack? My 87 spree came without one and I can't find one anywhere so I want to attempt to weld one up and would greatly appreciate some accurate dimensions to get it right.

Thanks!

Scooter Swap Shop sells the MLM pipe for the spree, albeit a bit expensive.

If not I see them pop up on eBay pretty often. I also have my old one laying around but it would benefit from some tlc. Let me know if you're interested

Sorry for disappearing for a while, life gets in the way. Are you saying the little spark plug cap should stay on the screw or should be removed?

Thanks!

Noiseguy, the cdi is brand new, I bought the malossi one off of scooterswapshop before doing my due diligence and just buying a stock one... I tried putting in the old one and there was no difference. Maybe I just got unlucky and have two bad ones. Did the same with the ignition coil. That being sai...

Ok, I checked the all the possible resistances from the manual and everything is to spec. I even popped the fly wheel off to check the stator visually and it looked good. The only thing I haven't checked is the engine kill switch. The starter works and cranks the engine, just no spark... Could it be...

Alright so I checked the pickup coil and it gave me a reading of 120ohms... In spec. Looks like I'll be spending plenty of time with a multimeter over the weekend

Thanks!

Thanks for the tip, do you know of resistance specs on the oem pick up so I can pull it off and test it prior to pulling the trigger on a new one?

Hi, I recently bought a 87 Spree project and have just finished reassembling it, however, I am getting no Spark and the Scooter will not start as a result. I have replaced the ignition coil and still nothing. The headlight does not turn on when you kick it and the blinkers and brake lights work perf...