Honda Spree and Elite 50 Forums

Noiseguy not uure where at in Canton you are at, Stony Creek motersports in Bellivelle was going to open up my SB jug for $70.00, untill I found another on E-bay for $4.99. It was guy with hiped piston, recieved pictures of bore and it looks good think he broke the piston skirt geting cylinder off.

is it opening jug for larger dia piston?,

I used a 1/4 28 tap to cut new theads in carberator, & replaced bolts with socket head cap screws ( allen bolts).
A fine thread 1/4 inch tap will be cheaper than heli-coil kit.
Also starting screws with allen wrench, I found easier to start screws strait.

looks like a lot of good parts, only if it was local and not in texas.

I live in Willis, small town south of Ypsilanti.

the petcock on bottom of tank is good, no fuel just mataining vacum presure for diaphram. Going to check out bystarter at work tomorrow. Manual said 10 ohm max.

O.K. I see in manuls where to chane clip location for jet will try to lower needle, and check bystarter

I think so to, have tryed the adjustment jet on side of carb and not getting any change ( not idle screw ). Blowing lots of smoke thought it was oil maybe to much gas. could bystarter be shot and allowing to much fuel to flow.

Scooter hard to start, had fuel leaking from carb o set floa to 12mm when upsie down needle & float workig great. But I drain carb into spray can lid and pour into carb with air filter removed. Reassemble air cleaner and starts real slow with trottle ide open revs up slow & I can back off th...

bent float under needle valve not leaking fuel. YEA!!!!!!!
going to get a couple of plugs and work from there, thanks for info.

thank you, parts dia was good to see. Going to try to mess wit float I don't think it is making needle valve shut off fuel.

Fuel is coming out near the slide, thru above throut , also the back where air cleanr clamps on. Not sure about adjusting float maybe bending where needle contacts with float. not sure if there should be a seat for needle, I could have missed placed, when I had carb a part

Maybe, I am over looking diffuclity. The needle has three flats on sides, a head where it clips onto float, and a rubber tip. The hole the needle goes into on cab appears to be round. So it is not keyed by the flats, I may be misstaken but, I think the flats are clearance to let fuel around ?

Scooter frame has SB50P, does this mean it was the cheeper of the two

Yes bwl drain has screw with jet type tip, and is all the way in. is there a removable seat for needle or float out of adjustment. Have thought of tring to bend platis float.

I start scooter and a lot of fuel is running out of carb. claened carb, checked out needle valve looks good. It has rubber tip to seal off, is there a removable seat that I may have miss placed ? scooter start and run pretty good till the carb over fills. Also is the SA50 a Spree & SB50 a Elite ...