Honda Spree and Elite 50 Forums

So Ive been playing with this 90cc kit and a 28mm OKO carb. I was wondering what is a safe rpm to rev up to? On a nice day itll hit 10k and stay around 270 degrees on my gauge. How much heat transfer does the spark plug sensor not read?

So Ive been playing with this 90cc kit and a 28mm OKO carb. I was wondering what is a safe rpm to rev up to? On a nice day itll hit 10k and stay around 270 degrees on my gauge. How much heat transfer does the spark plug sensor not read?

So Ive been trying to find a throttle cable that works with the OKO Carb but that is 10" longer. Has anyone experience with the extend a cable kit? Or besides a custom motion pro?

Looking at getting a jet kit with the 28mm oko carb but I dont know what range to get for this size motor. Im running a 126 main jet in my 24mm so I can get a pack of jets sized 140-150 or 150-160 or 160-170. Im thinking the 2 larger packs for the 28mm. Am I correct or should I shoot for the smaller...

I connected the tach onto the trigger wire for the coil. I installed a new crimp end over both wires. I will take a shot of the vari when I get a chance this evening.

Hey, Currently Im running my 87se50 (af16e motor swap) I have the mhr racing kit, 24mm oko carb, ct intake, and a pg long exhaust, polini ruckus vari and 8.2 gears. I pull to 60mph extremely well and up to 65mph with a good tuck at the right time. But thats where it maxes out. I know switching to a ...

What fan cases should I look into for fitting a 90cc kit. The right fan shroud fits over the fan but I will have to notch out the spark plug, the left case is far from fitting. Where could I find cases to accommodate the size issue?

Hey guy, So I have a left crank case from an Af18e with complete transmission, stator and rotor.(the left case bearing was blown out and I happen to have a replacement) I have an af16e crank and right side crank case. When I mocked up the stator to the af16e case the ground that would attach to the ...

I used a 25mm bmx stem. I used a stem extension and cross drilled 2 small bolts through the neck for a more secure mount. Dont have to cut any plastic but had to make custom cables and I eliminated a bunch of the electrical.

So check my battery and started going through the whole system. Battery is sitting at 16.5 volts. Could that be my problem? What would cause that?

i moved the kill switch down onto the dash plastic. I also moved my high low beam down too. Dont have electric start so no reason for the button.

So I swapped a bmx stem and handle bars on my 88 elite last night. Test rode like a champ and when I got back onto my lift it wouldnt start again. I checked the coil and cdi. Not the problems. So does anyone have the tests for the alternator and stator? That would be my only other guess. It makes co...

So Sunday is the Toys for Tots ride here in Chicago. Is anyone planning on riding in it. I have 6 fellow scoots going with me and a bunch of friends who ride. Requires bringing a toy and showing up.

Hello, Its an 87 elite se50p completely stock. Clean air filter installed. I cleaned the carb and changed the spark plug the other night. The scoot will start up and run higher in rpms but once it warms up it returns to idle and then dies out shortly after reaching idle. If I give it some gas at the...

Has anyone ever played with a yamaha jog or have a time riding one. is it worth building up. I know of a zuma that can do 60plus but how fast does everyone think a jog could go