Honda Spree and Elite 50 Forums

Hilarious

" IF YOU NEED WORKING PART - THIS PART IS NOT FOR YOU."

Expensive and awkward. Better off throwing it in a fire.

Welcome, post in the "wanted/for sale" section.

It's been awhile since i had one apart.
You might need to unhook it from the gear, put spring into place and then use screwdriver to hook it back onto the gear after gear is in place. It can be tricky, good luck!

Try to get in there with a screwdriver and push the big spring into position. It is under the gear preventing the gear from going all the way down.

vette76 wrote:crap.. i'm intrigued.

I can pm pics if you want

:*: I tried but pics will not show. I tried image code and direct links.

Hi Yan

I did rings on my 87 awhile back and had the marks facing down. It acted the same as yours is. Flipped them and it started right up. If everything else is good it's worth a shot to check.

Did you make sure the marks on piston rings are facing up?

The ONLY way is to spend an evening stripping and splitting the cases, knock out the bearings, and wash and reassemble with new parts

Hey swimmingfree..

Motion Left Mopeds wrote:I require a $50 non-refundable down payment. The total cost of the pipe is $180, FREE shipping to the lower 48.

I tried going to the cite listed below by ODIN for the variator parts....but I can't seem to find them on that page "http://scootspecs.wordpress.com/ go here for the variator and maybe a set of 9:1 gears. 92.00 shipped. maybe a set of grabber springs" I am an Old Man in need of some help~...

Too bad i'm not closer. I'd miss a lot of races

Get a pint of "boiled linseed oil" (Home Depot or Lowes) and a pint of paint thinner. mix them 60:40 (thinner:linseed), stir. then while wearing gloves, squirt the mix onto a clean, lint free towel or a wax/foam pad and then wipe it all over the plastic parts as if it were tire shine. That...