Honda Spree and Elite 50 Forums

My friend just put together a ministroker nickle sil ported by tru72 and it is the fastest bike around here. Hes a bigger bradda and he still haaaaaama. He had a mini stroker corsa prior and it blows it away

JAC3 wrote:

kingkamehameha wrote:What gears are you running

8.4:1

On a sym?

I would if I had it, plus I was also concerned about clearance with the spree's panels. Might buy one down the road, if i can confirm that it would fit ok. If you ported it correctly you should be using a smaller jet and dont run it without the airbox. Fixed pilot will never compensate dont learn t...

What gears are you running

Dont port anything. Clean the case get the crank balanced and put new bearings and seals cherray! Or spend a hundred more on a stock Af16

maddog wrote:This was a spree forum only untill i started posting elite-s mods, so that red elite-s thats mine, wiseguy will confirnm this, yes i keep what i build

Lies

Nice pipe wheelman! Im digging the 49rr decal haha. Did you decide on gearing? With the malossi straight cut 7.98 gears i was able to cruise at 55 on the highway at quarter throttle. Why not give the extra head gasket a try? I was running remarkably cool at 320 wot 280 cruising and those were small ...

Mathematically you should be turning x rpms and getting x mph according to the gear chart. But Like baka said if your motor doesnt have the balls to push the gears then your not going to reach that x mph with the x rpms. Theres big heavy guys whacking high speeds on 72cc with good tuning. I dont see...

Build a stroker if you wanna use those gears so bad haha. Theory and math are everything. Your real stubborn wheelman why cant you take advise from others.

The 7.58 gearing is the limit any taller and you will strain your motor and unless you have a hill it wont help your top speed much

Tru72 had an arnada with a nickle sil mini stroker and 9:1 gears that went over 70. Your tuning is what gets you to free way speeds. If you cant get past 70 with those 7.58 gears then something is wrong.

Wheelman those gears will strain your motor and cause premature wear end of story.

Oahu guys sure know how to build nice bikes

Mhr is great made out of aluminum extra cooling action. You should match the boost port and put fresh bearings and seals or its a waste of money

paulpauly7 wrote:so being lighter it works like a lightened flywheel on a car leting the engine rev easyer less rotating mass

Yup