Honda Spree and Elite 50 Forums

Hey I added led blinkers to me spree trying to figure out how to get them blinking independent again… I assume I need a led relay some one also mentioned diode kit.? I’m not great with electrical but I know the basics.. thanks. And cheers

update . Drilled out the petcock and added manual fuel shutoff. Haven’t had a single issue. That was a new petcock to.. my elite ch125 just started stumbling at wot and starting rough.. changed that petcock aswell ,which was also new, and that runs great… both machines both the same problem and both...

Everything I do leads me back to fuel delivery. I’m going to try to buy another petcock and maybe a bigger diameter vacuum line that doesn’t work going to have to put it away for a while or drive it off a bridge.. lol

I replaced both crank seals. I’ve literally been messing with this thing all summer for my son. I have a couple other vintage Honda scooters and I have no problems getting them to run. This thing is driving me crazy.. i’ve sealed everything with Honda bond except for the carb to manifold. I do have ...

What are the odds the case leaks.? I’ve taken the engine off 3 times and checked it out no obviously visual leaks. I don’t have a pressure case tester.

That was exactly my first thought got new petcock and clear line. I don’t have plastics on it.sometimes I’ll pop vacuum line off and suck and it will pump. Other times there fuel in the line.. I’m clueless

Hey guys. I have two Honda spree‘s one of them got running perfect. The other one on the other hand I just cannot figure out. Gas tank clean and petcock New fuel line and filter..New vacuum lines New piston and rings ..Head gasket and base gasket with Hondabond..Carb clean with new o-rings…Reeds goo...

Hey guys I put a new petcock on my spree as well as fuel line and vacuum line. I also drilled a hole in the gas cap to help flow…Randomly the scooter will die your because fuel flow stops…I have to disconnect the vacuum line and suck on it again and It will start right up.. any idea why this happens...

Have you tried taking off gas cap or drilling a small hole through it, to help the tank vent and inprove fuel flow? ..

Yep i did try that too.. no leaks... it died again today.. compression is 150 psi.. changed vacum line and oil pump to manifold line . Oddly it ran well. Raced around WOT fine

My son just pushed it home after it died. Got alittle bit “jumpy”and died. I checkednspark and fuel which were fine and it started right back up for me..?

It does affect the speed when i adjust the screw. The engine will die out or rev up

Hey guys. I have an 86 spree with full tuneup. Plug air filter carb clean fuel line fuel filter new gas . Carb slide screw it’s adjusted and idle air screw is one and three-quarter turns out ... she idle well untill you hit the throttle. If your on the stand the throttle just pins like its stuck . W...

I haven’t had a gasket on my belt cover case since i got my spree 5 years ago if that means anything to you

Try to crack the gas cap open