Search found 1562 matches
- Tue Jan 03, 2023 6:37 pm
- Forum: Performance Technical
- Topic: Trail Setup for Stock ‘01 Elite
- Replies: 4
- Views: 3777
Re: Trail Setup for Stock ‘01 Elite
You would just need a cross bar from the front somewhere like the neck, to the middle of the frame in front of the motor somewhere. I've seen it done for drag racing and it was in good taste and not overly invasive. That just keeps it from folding in half if you bump into a tree
- Mon Jan 02, 2023 8:11 am
- Forum: Performance Technical
- Topic: Trail Setup for Stock ‘01 Elite
- Replies: 4
- Views: 3777
Re: Trail Setup for Stock ‘01 Elite
I can remember my first stock bore SA50 with yms pipe, 9:1 gears, upgraded clutch springs, Polini vari w/7gm. rollers and new oem belt. That setup got me to just about 54 mph and once I installed metro tubeless wheels and 90/90/10's I think it was 58 mph? Maybe that was with the wind? It's been abou...
- Sat Dec 31, 2022 7:09 pm
- Forum: General Discussion
- Topic: Cvt tuning Honda elite windjammer
- Replies: 3
- Views: 859
Re: Cvt tuning Honda elite windjammer
Take it easy for a while. You can't expect that corsa to let you run wot for any length of time until after at least 400-500 miles. Bump up the pilot jet a little until you're sure the rings have seated properly. You will know when you've got it too rich because the air/fuel mixture screw will have ...
- Sat Dec 31, 2022 4:37 pm
- Forum: Technical Help
- Topic: Cvt tuning
- Replies: 1
- Views: 591
Re: Cvt tuning
The cylinder is soft-seizing - you may have to up the pilot jet to 50-52. You aren't the first guy to have this happen to - it's common until you understand that it's not a factory race motorcycle and you will always be tuning it to make it run better. Be happy you didn't waste your money on a strok...
- Sat Dec 31, 2022 4:27 pm
- Forum: General Discussion
- Topic: Cvt tuning Honda elite windjammer
- Replies: 3
- Views: 859
Re: Cvt tuning Honda elite windjammer
How many miles on that bore?
- Mon Dec 12, 2022 1:34 am
- Forum: Scooter Showcase
- Topic: 2001 Elite SR Build
- Replies: 9
- Views: 11376
- Sun Dec 11, 2022 7:33 pm
- Forum: Technical Help
- Topic: Engine Low Power, Bogs Down When Accelerating Hard
- Replies: 7
- Views: 1129
Re: Engine Low Power, Bogs Down When Accelerating Hard
Thanks, it has all of the power though untill it gets too around 34 mph and I meant it doesn't seem to be a vacuum issue sounds rich or like the or like it's not getting enough spark almost on the high rpms , could be the float but idk Be absolutely sure the spark plug cap is making good contact to...
- Tue Nov 29, 2022 4:57 am
- Forum: General Discussion
- Topic: AF16- I have no idea what this tube is for
- Replies: 1
- Views: 608
Re: AF16- I have no idea what this tube is for
It's a ventilation tube for the gearcase. It tucks up into the rear of the air box. or just left hanging in a modified motor application. Don't plug it - it needs to relieve pressure as necessary.
- Fri Nov 25, 2022 8:54 pm
- Forum: General Discussion
- Topic: Wheels for Af16
- Replies: 1
- Views: 589
Re: Wheels for Af16
Yup! Those fit. I think the met wheels fit up to 2012 or 2013. You must use the elite front hub for use on the elite. The rear is plug and play. You have to search around for wheels. If you want to go disc front then you can search the Asia/Europe market or ask Scooter Swap Shop. Those guys get the ...
- Wed Sep 07, 2022 9:51 am
- Forum: Performance Technical
- Topic: boost porting
- Replies: 2
- Views: 3805
Re: boost porting
I believe that it is most important to match up the case to the cylinder boost port. Case in point; I had cut a boost port into my block to match a malossi cast iron cylinder and then when I went to install a polini corsa on to that block, it would not rev or perform well because of that mis-match b...
- Sat Jul 16, 2022 9:30 pm
- Forum: General Discussion
- Topic: Member Check-In thread
- Replies: 25
- Views: 10134
Re: Member Check-In thread
I would vote with MotorMike on the question of any new ventures. I don’t think I could contribute much
- Fri Jul 08, 2022 6:28 pm
- Forum: General Discussion
- Topic: Member Check-In thread
- Replies: 25
- Views: 10134
Re: Member Check-In thread
Yo, Mike. Wasup?
- Fri Jul 08, 2022 6:23 pm
- Forum: General Discussion
- Topic: Waving
- Replies: 26
- Views: 34566
Re: Waving
I wave when I feel like waving but I just love the sarcastic story in first post
- Sun Jun 05, 2022 7:15 pm
- Forum: Performance Technical
- Topic: How To Video: Change tire at home
- Replies: 1
- Views: 3906
Re: How To Video: Change tire at home
What, you work at Amazon?Thanks for your time and effort - I applaud you micbergsma
- Thu May 26, 2022 5:35 pm
- Forum: Performance Technical
- Topic: Elite SE50 Mods
- Replies: 15
- Views: 16284
Re: Elite SE50 Mods
Those are stock wheels on the Japanese model "Honda Dio ZX Live" Thank you! Will the rear wheel just bolt right up to a stock AF05E? Also I found a G Dash whole front assembly on an auction site, but I'm not sure how to get it to me, since they won't ship it due to it being apart of their...