Honda Spree and Elite 50 Forums

Bear is absolutely right. I asked my instructors at school today and they said go with the picture of the assembled bike. Not the drawing. I was also installing them backwards on my Spree w/out a problem though. I fixed mine today.

The Honda manual Section 6-3 has a photo, but might as well post one... sooner or later I will remember it by "the tab goes on the back right hand side", or "the angled fins go on the fan side". BTW - Thanks Bradthree for the parts! :thumbsup: Yes in the manual 6-3 shows the hea...

http://phoenix.craigslist.org/nph/tls/1827466613.html

Perfect for you.

tjrriffic wrote:I'll ride as soon as I get my elite put back together. I'm also up in north. Hey Gingerbread, isn't that the one for sale? I'm in morning classes at that school

Hey! Yeah I'm in afternoons and have been trying for a week or so to sell it.

Not that I know of. In what part of town do you ride your Spree? I ride in North Phoenix and I have seen a few at ASU.

Ok I'm a dork! I tried to copy the link right but it keeps going back to the pipe. If you go to the site under Jog 50 you will see some carbon fiber reeds, that is what I was thinking of for crisp throttle response. The other link was to main jets. Right now I have order a complete new OEM top-end m...

Awesome thanks. Here is the link I meant sorry. https://www.battlescooterstore.com/sess/utn;jsessionid=154c304dd3c3107/shopdata/?main_url=go.shopscript%3Fa%3DLV4077 Would these make any noticeable difference on throttle response? https://www.battlescooterstore.com/sess/utn;jsessionid=154c304dd3c3107...

I ran the VIN it's 1993. eliteguy50 is # 19 a restriction washer? http://www.apachemotorcycles.com/fiche_section_detail.asp?section=21786&category=Scooters&make=YAMAHA&year=1993&fveh=555 Is this the pipe I want? https://www.battlescooterstore.com/sess/utn;jsessionid=154c304dd3c3107/s...

You could get $400.

Ok i'm going with 92-01 CY50?

I think I will tomorrow morning. Do you what year that could be?

The kid said he dose not know anything about it.

http://phoenix.craigslist.org/nph/mcy/1819074553.html

Yeah i know that but for his midrange 1/4 - 3/4 which the needle affects is still important. I would hate to see a brand new 48mm kit fry.

I agree with bear, way too lean. Make sure your jet needle is in either the third or forth position. I would also try a 105 and 110 main jet to rich en your air/fuel mixture at WOT . For better take off try your air screw at 1/2 turns out.