Honda Spree and Elite 50 Forums

a 5lbs parcel cost about $80 shipped through ems

you. wont have any issues using a 28deg angle cog belt vs a 30. the belt will breakin to the angle if the drive face and pulley face. and any ways most aftermarket pulleys have a steeper face anyways. the gates belts all fray at the edges if thats what your talking about wheel

DONT FEED THE TROLL!!! YOU GUYS KEEP RESPONDING TO THIS TROLL AND HE WILL STICK AROUND. THIS IS HIS WAY OF FISHING FOR TUNING INFO. STRAPLINE AKA IDRANCER AKA TRAINS420 aka........ this guy keeps coming back. you guys get fustrated with his comments and thats what he wants to do. STOP PLAYING HIS GA...

fill up and use what it says on the pump on how much gas went into the tank. then put your oil amount to the amount of gas went in according to what the pump says. if you have a bbk, use the highest grade fuel you can find.

do you have the original piston? what brand bore is that?

check for air leak or exhaust leak. the white on one side is the tell tale sign. try tighten the exhaust flange nut and see if its loose. check head bolts too.

what 64cc kit are you using? if you got a big bore you should for sure be going faster than 40mph. something else or a bunch of stuff is not working right.

also a ruckus variator will not be effective if your not using a 18mm wide belt.

the stock motor revs well past 6600 rpms. keep in mind a stock 87 elite 50 with just a keli variator with 10to1 gears,90/90-10 tire , .30 milled head ,stock carb/airbox/reed cage 90 main,and unrestricted exhaust will top ot at 50-55mph. 55 on a slight hill or wind to your back. that equals in the mi...

you are running .40 thick reeds so that will restrict flow some. stock is closer to .25-.30 thick carbon reeds on how it flexes. 87 elite 50 came with 10g rollers.

ok its been a while and the 2013 racing season is starting up. here is the link for cup races and local races.
http://pacificscooterracing.com/ . The next race is this sunday 4/28 at The Ridge raceway in shelton,wa

mmeadows wrote:to reiderate my queation can i put a 24mm carb on a 26mm intake?

yes. you can even put a 19mm if you want.

on the main you shouldnt have to go bigger than 152 and thats for big strokers. you might be in the 138-142 range

does the crank spin? there will be little resistance from the crank seal

if it wont tighten then its good. once the crank bottoms out on the bearing its good. there will be a gap between the case and the crank weight about 1/8th of an inch gap.put oil on the shaft where the bearing is going to slide on do it goes on easier.