Honda Spree and Elite 50 Forums

1965 Fuji Rabbit Junior scooter. Anyone heard of em? Picked one up and was just looking to see if anyone has had personal experience with this cool little machine.

Is there any option out there for replacing the front fender on a 94&up SA50?

So I am currently running a 160 mj with the needle clip moved up one position from middle. When I go out and ride everything is perfect for about 30min. Once i roll on and am cruising 50ish it cruises fine. If I roll off and then back on it bogs and gargles and slowy drops in rpm. If i come to a com...

Inker whats up sir

Okay check leak down and im good. Changed to a fresh spark plug and lowered the clip (towards the pointed end) 2 notches. Its about 65 out and I pulled 315 at wot for a mile and a half. Temps didnt go above 250 until 1/2 throttle to full throttle. Poor tuning after all. Im pulling mid 60s now with t...

Okay, Ill check back with results soon. Sad news is th Honda near me wont have the plug until friday.

How much pressure should I be sending into the motor for the leakdown test? I have a regulator valve on my tool and I can push up to 200 psi. I know thats way more than needed. Should I be matching my compression or running a little less into the motor? Thanks guys. Ill try and get some pics uploaded.

Ill be checking again tomorrow in the morning. If it was an aluminum kit I would expect to see higher temps and the ability to withstand the heat. So back on the lift to see whats happening.

Im running the 10mm ring around one of the studs. Im at a loss of what to look for. So I will be swapping plugs soon and seeing what that does.

Its a 50mm kit from taz. I did a compression check and I'm at 140psi. Did a leak down and nothing seemed wrong. Reeds seem to have a tiny leak. It has been addressed same temps. I switched to a 162 main. It has way more pull and extra top end. But same temps. Got it up to 390 after a mile flat out.

I did some riding tonight about an hr and a half cruise temps reached 390-400 with the choke in some spots due to the cold air. Im in Chicago suburbs so weather changes daily. Ive been switching main jets between 162-168 and the a 58 pilot some days. Runs like a beast cruising 60mph plus on longer s...

Hey, so im out riding my 81cc kit from taz with a 28oko and a pg long. I'm running a 55 pilot and a 165 main. I can't keep the scoot from running between 275and350 degrees. Is this normal? I've checked the plug and it looks correct. I also checked for an air leak and couldn't find one. So I'm wonder...

Are all af16e kick covers the same or is it different based off the model? Is there a way to tell the difference between them?

I was playing around with my friends zuma and well it was idling fine when it all of a sudden it started to sound like the throttle was open more while it was idling and now it wont start. Carb is clean and spark plug is soaked in fuel now. I have confirmed spark is good. No jetting has been changed...

Well I figure I lose some heat since the sensor sits on the sparkplug. Its the taz kit 50mm. I know its not to bad on temp but what is a dangerous temp to reach? anything over 325 or so?