HOW FAST DOES YOUR SPREE GO?

diosoljah · Post by **diosoljah** » Thu Dec 22, 2005 5:04 pm

My ped is down for the count! Rear pulley broke the welds right off the spindle!

darat · Post by **darat** » Thu Dec 22, 2005 5:12 pm

how in helll did u do that

maddog · Post by **maddog** » Thu Dec 22, 2005 7:03 pm

thats strange, i can't see any welds on the rear pulley? vt cycles sells them cheap.

diosoljah · Post by **diosoljah** » Fri Dec 23, 2005 2:10 pm

Okay, its the rear Pulley, where the clutch and torque driver sits on, Ill post pics later, oh by the way, It was the first test run since increasing the compression from 115 to 135 psi. My speed when It broke was near 50-60mph. I was like DANG, MuthaF#@ker, Had to push for about 2 miles. just got a whole new tranny setup, The ZX Tranny set up, Higher rear Pulley, adjustable torque driver, and get this a centerspring bearing to reduce drag and friction of the center spring oh and the belt is wider too.

diosoljah · Post by **diosoljah** » Sat Dec 24, 2005 3:53 pm

started a new thread in performance technical about the ZX tranny coversion