Just a few quick ?s on rebuilding my scooter. I have replaced all the parts that were rusted through and one of the cases. Bearings and everything are in so my ?s follow.
?1 Do I have to grease or lube the bearings in the cases.
?2 what do you gentleman recommend for jetting with a 70cc kit
?3 Should I put some thin oil on the cylinder wall before installing the piston and rings
scooter rebuild 88 sa50
Moderator: Moderator
scooter rebuild 88 sa50
88 SA 50- Af16e swap
87 Se 50 - 01 Af16E build
87 Se 50 - 01 Af16E build
-
Wheelman-111
- Moderator
- Posts: 11319
- Joined: Wed Oct 22, 2008 5:09 pm
- Location: Deepinnaharta, Texas
Re: scooter rebuild 88 sa50
Greetings:
PM sent.
1. I use Honda GN-2, HP-2 or whatever brand of 2-stroke oil you prefer.
2. I'm not aware of any 70cc kit for the SE/05. 47mm = 65cc. Jetting up to low-90s for the bore kit alone. More if intake mods and still more for aftermarket exhaust. I had a home-rolled 101 before switching to an Arreche carb.
3. Paint the piston ring lands, rings skirts and bore liberally with the same oil as #1.
PM sent.
1. I use Honda GN-2, HP-2 or whatever brand of 2-stroke oil you prefer.
2. I'm not aware of any 70cc kit for the SE/05. 47mm = 65cc. Jetting up to low-90s for the bore kit alone. More if intake mods and still more for aftermarket exhaust. I had a home-rolled 101 before switching to an Arreche carb.
3. Paint the piston ring lands, rings skirts and bore liberally with the same oil as #1.
Wheelman-111
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH