Just picked up a CH150
Posted: Tue Sep 29, 2015 8:34 pm
Hey guys, just joined. Not new to scooters, but I AM new to this CH150 Elite. It was a mess when I got it, the PO pulled the carb off and had no idea what he was doing. Vac lines were off, screws were loose, oh and there was RTV IN the bowl. What a mess.
Anyway, in standard fashion when something new rolls into my shop, I tore it apart to learn it. I now know lots of things about this, but I still can't get it to do anything more than idle. The MAIN thing I am dealing with right now is sorta embarrassing. I can't get the air inlet tube to stay on the carburetor. Am I missing something? It should just pop on there and then tighten down with a clamp, correct?
I got all the vac lines situated, a new fuel line, and I even tested it by sucking on the hose going to the fuel petcock to make sure fuel flowed.
Anyway, here's some pics of this thing of 80's beauty, and for good measure I have included pics of my other Hondas and misc toys.
Anyway, in standard fashion when something new rolls into my shop, I tore it apart to learn it. I now know lots of things about this, but I still can't get it to do anything more than idle. The MAIN thing I am dealing with right now is sorta embarrassing. I can't get the air inlet tube to stay on the carburetor. Am I missing something? It should just pop on there and then tighten down with a clamp, correct?
I got all the vac lines situated, a new fuel line, and I even tested it by sucking on the hose going to the fuel petcock to make sure fuel flowed.
Anyway, here's some pics of this thing of 80's beauty, and for good measure I have included pics of my other Hondas and misc toys.