Page 1 of 1
LEDs on Spree
Posted: Tue Jun 27, 2017 2:21 pm
by kevinv710
Re: LEDs on Spree
Posted: Sat Aug 26, 2017 1:26 am
by Videonut
super cool
Re: LEDs on Spree
Posted: Sat Aug 26, 2017 2:52 am
by eclark5483
Now do like I did on my daughter's TaoTao:
https://www.youtube.com/watch?v=XglRuEtSgjo
Re: LEDs on Spree
Posted: Mon Aug 28, 2017 8:48 am
by noiseguy
You need to get a blue headlight bulb to match. While the assemblies a unit, the inner bulb is separate... you can remove it with a dremel and some careful cutting. Use putty epoxy (ala JB Weld) to install new.
Re: LEDs on Spree
Posted: Thu Aug 31, 2017 2:39 am
by ped
I like the leg Shield Kevin, that's different. Cool looking spree.
Re: LEDs on Spree
Posted: Thu Aug 31, 2017 3:30 am
by eclark5483
ped wrote:I like the leg Shield Kevin, that's different. Cool looking spree.
Oh yeah, now that you mentioned it, that is pretty cool. Wasn't even looking at it, was checking out the lights.
Re: LEDs on Spree
Posted: Thu Aug 31, 2017 7:35 pm
by kevinv710
Thank you, Gentlemen for good feedback...floorboard and leg-shield, taillight and blinkers was broken and missing pieces when i got it, so i just threw in and made something happen that legal enough ride-able for it.
When i posting this up, my all intentions was to learn and share to someone who interest add-on LEDs on Spree.....The basic setup to LEDs functioning properly not only complicated alone, but costly, times, skills and knowledge. I was lucky enough to find parts and with my limit knowledge, i was able to keep it under $30 budget, still got the job done.....Instead of writing down steps by steps how to, that might have confused you, due to my bad writing English skill, i decided to post up more pictures, some of them might hint you how's it works. Share with me, if you know how to set it up better, parts, anything...Again, thank you for checking out!
