sully's 86 spree build
Moderator: Moderator
Re: sully's 86 spree build
I had someone impact it on. it was the crank gear. I now have it running and think the throttle works. its spinning the belt but it wont go anywhere. even off the ground the wheel wont turn. I hope the spree throttle works in the aero carb, it looks way shorter on the needle side. Ill need to do more research to get it going. I want to ride so bad!
Re: sully's 86 spree build
got the starter and everything figured out. I've been able to hit 32 for my top speed so far , but today it would only do about ten uphill. I need to tune it better. I'm guessing it did 30 bexause the muffler came a little loose but then it started rattling so I pulled over not to burn it up. I think it's leaning out. its really sputtering but I was doin 25 easy at 1/4 throttle. it just bogs after more than 1/4 throttle. is this a carb issue?
- patthesoundguy
- Moderator
- Posts: 3159
- Joined: Mon Mar 29, 2010 11:38 am
- Location: Nova Scotia, Canada
- Contact:
Re: sully's 86 spree build
You are running the pop cap for the restriction in the intake right? Because you diddnt have an air box. Did I remember that right lol? You may just need to open the holes one size at a time untill it goes properly. Or it could need smaller holes. A new plug and a plug chop may be the order of the day. A temp gauge would be super handy.
Dude! Ya Can't Fix Stupid!
84 Spree stock
84 Spree Dio AF18E MHR Cylinder Arrow Pipe 28mm OKO
80 Express, 47mm DR BBKit, Weak Ends Intake, Boyesen Dual stage reeds, 19mm Delorto carb, MLM pipe
79 Express
85 Aero 80 stock
84 elite 125 stock
84 Spree stock
84 Spree Dio AF18E MHR Cylinder Arrow Pipe 28mm OKO
80 Express, 47mm DR BBKit, Weak Ends Intake, Boyesen Dual stage reeds, 19mm Delorto carb, MLM pipe
79 Express
85 Aero 80 stock
84 elite 125 stock
Re: sully's 86 spree build
yeah it's been cut to match the original airbox hole. it does right around 35 like I suppose it should? it's a 1985 nb50.