Honda Spree and Elite 50 Forums

This is the best build to come along in a looong time. Looks great, ped!

Meatball wrote:This is the best build to come along in a looong time. Looks great, ped!

Thanks meatball it's coming together. The reason you don't see many build's it's because everyone's riding. Hehe.

there are special "slim" crankshaft bearings that are used with this crank.

if you use the stock bearings the case will not close and seal together.

i have slim bearings for sale if you need a set.

lmk

btw nice build very meticulous very nice

ped wrote:

Where did you get that cutting tool?

Cool build!

HI808SYM wrote:there are special "slim" crankshaft bearings that are used with this crank.

if you use the stock bearings the case will not close and seal together.

i have slim bearings for sale if you need a set.

lmk

btw nice build very meticulous very nice

Thanks. The Kit came with the bearings.

wwolvert wrote:

ped wrote:

Where did you get that cutting tool?

http://www.ebay.com/itm/Honda-Dio-Elite ... SwSlBYucVt
Hi, I bought the tool on eBay. It's very hard to work with this tool. You have to take off very light cuts. You also have to use a Dremel to finish. There is some skill involved. I recommend a machine shop. The tolerance are too close and easy to screw up. Also it's not easy to cut the top of case for the Big Bore cylinder. Good luck

Revolutionary wrote:Cool build!

Thanks Rev.

Hi Forum. The water cooled motor is on hold. I'll add the air cool photos, which is the same 54mm build.