Honda Spree and Elite 50 Forums

Gearhart wrote:Cleanest way to do it imo is to put it right behind the front wheel in that plastic.

Hi Gearhart.I was looking at that. The front wheel is very close to the frame. I don't think it will fit?

Nice... I like the jb weld case bracing!

benji wrote:Nice... I like the jb weld case bracing!

No bracing Ben. JB Weld is only on one half of the case to add thickness, meat ,for sealing.
The other gray stuff is Permatex grey RTV sealer.

Hi forum. My friends spree is running slow. Can't keep up with traffic. Let's see if we can fix that.

Forum, we going to make it a 129cc

Have you seen these cranks, ped? https://honolulu.craigslist.org/oah/mpo ... 26044.html

Meatball wrote:Have you seen these cranks, ped? https://honolulu.craigslist.org/oah/mpo ... 26044.html

Good to know. thank you. I do like the PG crank. They can take a beating.

WOW! Nice work Ped! God forbid you have any air leaks on that monster! Do you think the stroker pipe you have will work well? Props for your extra efforts on the build!!!

This is NUTS!! Very mean build Sir!!!

bonesv wrote:WOW! Nice work Ped! God forbid you have any air leaks on that monster! Do you think the stroker pipe you have will work well? Props for your extra efforts on the build!!!

Thanks Bones. The Stroke of pipe that I have will not work. I have a different pipe for my friends setup. A large tiada pipe.

Xxbeejay45xx wrote:This is NUTS!! Very mean build Sir!!!

Thank you sir