trouble getting over 27 mph. help please

[iceman77]

i still fell you expipe is full and plug

when i take the exhaust pipe off it still has the same issues as it does w/ it on

[swimmingfree]

if the pin in the slide is off not good !!! shood be in the middle..
if the air screw is no set right not good.. the book setting is a starting point ..

to set the air screw.. start the motor on the stand let off the brake turn the air screw in or out and lison to the motor . when the motor get to a hights rev its set .. then just re set the idle screw to a low idle..

swimmingfree

[iceman77]

if the pin in the slide is off not good !!! shood be in the middle..
if the air screw is no set right not good.. the book setting is a starting point ..

to set the air screw.. start the motor on the stand let off the brake turn the air screw in or out and lison to the motor . when the motor get to a hights rev its set .. then just re set the idle screw to a low idle..

swimmingfree

ok, the pin is in the middle.
i set the air screw again. it idles perfect. but when i give it anything over a 1/4 throttle she falls flat on her face.

[swimmingfree]

it was or you put it in the middle????
swimmingfree

[iceman77]

it was in the middle

[swimmingfree]

on this post is something from bear on carbs on the first page http://www.hondaspree.net/phpBB3/viewto ... =4&t=21616 the pin on the slide has 3 or 5 notch?? you may want to try moving it and see what happens if it get go the other way.. how is the bystarter ????
swimmingfree

[iceman77]

how is the bystarter ????

bystarter works good.

[gixxer1000chad]

check your manifold for cracks or a gasket leak too..

[iceman77]

check your manifold for cracks or a gasket leak too..

manifold is good. i took the jug off and it has a crack on the cylinder wall.

[Mystic]

you are having all kinds of trouble arent you?

[iceman77]

couldn't the crack in the cylinder wall be my whole issue? when it get warm the crack probably expands making it even bigger.

[Bear45-70]

ok read you input got more qustion the plug was black ??? you running rich not lenn i think ..
were is the pin on the carb slide set???
the air scru were is it set???
swimmingfree

by the look of the plug i figured i was running lenn also.
not sure about the carb slide sed.
i've tried the air screw in many different positios

You don't try the air screw in many different positions. You adjust it properly and leave it there. Why can't you people understand this simple concept?

[iceman77]

You don't try the air screw in many different positions. You adjust it properly and leave it there. Why can't you people understand this simple concept?

why do you have to be a * head. do you not understand the concept of being nice or not saying anything at all if you're going to be a *

[evilone]

Post some pics, i really want to see the cracked cylinder wall.

[iceman77]

i've got it at my buddies shop. i can probably get some later