Replacing piston ring type

[Tell me again]

Hi guys,first of all,first timer on this forum and im starting to like what i see!..I have a question about replacing my piston ring on my 84 Honda spree,one of them is shot and is the cause of all the smoke from the exhust.What i dont get is what piston ring on picture to get , standard 0.10-0.25 or serve limit 0.50?.I know they hard to get ,does anyone know where to get them or can i use a different ring or something similar,like a honda elite ring ?.Oh and the bore is in good condition

[jakubman1]

Get a whole.piston Kit from chopchop001 eBay

[MrJumps]

84 and 85 sprees have dished pistons the 86 and 87 have domed pistons. The head may hit on the domed piston on chopchop/tazland001 on here on ebay's piston because its the domed and not dished. I would ask him on ebay his name is chopcop*123

http://m.ebay.com/sch/i.html?sid=chopch ... efine=true

Ask him about this for I do not know off hand if will work without raising the head or swapping to a 86 or so head. Cheers

[benji]

Yup. If you need a ring you should probably just do a rebuild or a cylinder swap to a big bore. It's about the same amount of work haha.

[jakubman1]

Im using the dome piston on the 85 head and i dont have my piston hitting the head....or do i?

I dont hear nothing at idle

[MrJumps]

Like I said I am not sure for certain, but I would ask taz. It may be fine but I would have to agree with g9 to a point if the bore dosnt have any scratches your fingermail catches than just rehone and new rings and piston will do you.