Carb problem reving
Moderator: Moderator
-
spartan-spree
- BMX
- Posts: 33
- Joined: Wed Nov 02, 2011 10:07 pm
- Location: Lansing, MI
Carb problem reving
I just took apart my carb to clean it and put it together again and when I started it the engine started to go and it was revving fast but it's not the idle speed screws cause I adjusted and it did nothing. What part of the carb is doing this?
-
SuprasNsprees
- Elite
- Posts: 564
- Joined: Mon Jun 20, 2011 2:05 pm
- Location: saint louis
- Contact:
Re: Carb problem reving
spartan-spree wrote:I just took apart my carb to clean it and put it together again and when I started it the engine started to go and it was revving fast but it's not the idle speed screws cause I adjusted and it did nothing. What part of the carb is doing this?
you put the slide in wrong
'86 Honda Spree : taz stage3 w/ mild porting, head milled 0.015", and pulley mod. 2k+ mies on kit
'80 Puch Magnum MKII
'78 Maxi Newport. Polini 64cc case matched, hi comp head, Rito alum crank, delorto 21mm race, etc.
'78 PA50 Hobbit
'80 Puch Magnum MKII
'78 Maxi Newport. Polini 64cc case matched, hi comp head, Rito alum crank, delorto 21mm race, etc.
'78 PA50 Hobbit
Re: Carb problem reving
Last time I had same problem the slide was stuck.
-
spartan-spree
- BMX
- Posts: 33
- Joined: Wed Nov 02, 2011 10:07 pm
- Location: Lansing, MI
Re: Carb problem reving
Yeah I figured it out the o ring slipped and I had an air leak. Thanks guys you are always so quick and helpful in your responses.