1985 honda aero piston rings.
Moderator: Moderator
1985 honda aero piston rings.
i cant seem to find piston rings for my 85 aero on hondas web site.i think they might be disc.is there an early model elite that has the same engine as the aero that i could look for?I wanted to do a top end rebuild and i can get all the parts through honda except for the rings.
Re: 1985 honda aero piston rings.
also i thought the engines were the same from 85 to 87 but if you look up the piston the number is different from 85 to 87.did they change the pistons in these year to year?
- paulpauly7
- CB900F
- Posts: 1945
- Joined: Tue Feb 21, 2012 6:57 pm
- Location: nz
Re: 1985 honda aero piston rings.
just buy red efts bbk it can be used with the stock carb and stock exhaust
86 Nifty Fifty (spree)
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
Re: 1985 honda aero piston rings.
do you have a link to where ican buy one of these kits.
- paulpauly7
- CB900F
- Posts: 1945
- Joined: Tue Feb 21, 2012 6:57 pm
- Location: nz
Re: 1985 honda aero piston rings.
just pm red eft performance here on the board he will sort you out .He has some sort of super postal service working for him you will have it in you hot hand in no time
86 Nifty Fifty (spree)
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
Re: 1985 honda aero piston rings.
yes he could spend 185 on the best kit aviable
but i think he wanted to know where to buy a 20 part.
pod44444: the 85 aero engine was diffrent at the intake, so dont worry the rings will interchange. you can find those rings on aero50 from 85-87 and on elite 50 from 87-93. all those scootes use the af05e motor. you should be able to find them on a honda parts website. are you going to a dealer or website?
http://www.ebay.com/itm/Honda-Std-50cc- ... cb&vxp=mtr
or my honda dealer
http://www.beavertonmotorcycles.com/fic ... veh=131264
but i think he wanted to know where to buy a 20 part.
pod44444: the 85 aero engine was diffrent at the intake, so dont worry the rings will interchange. you can find those rings on aero50 from 85-87 and on elite 50 from 87-93. all those scootes use the af05e motor. you should be able to find them on a honda parts website. are you going to a dealer or website?
http://www.ebay.com/itm/Honda-Std-50cc- ... cb&vxp=mtr
or my honda dealer
http://www.beavertonmotorcycles.com/fic ... veh=131264
84 Aero af05e Ruckus variator, rear metro wheel, Leovince pipe ( work in process... porting , nh80 reeds intake carb)
Re: 1985 honda aero piston rings.
Rings don't interchange, I went through this after replacing the piston in my '85 Aero motor. While the piston's diameter stays the same throughout various iterations of the variated af05, the rings' thickness was varied.
If you're looking to keep it stock (and not have to premix) then make sure you get '85 Aero piston rings. I might still have the NOS set I bought, and would be happy to sell 'em to you if I can find 'em.
If you're looking to keep it stock (and not have to premix) then make sure you get '85 Aero piston rings. I might still have the NOS set I bought, and would be happy to sell 'em to you if I can find 'em.
1986 Spree w/ '87 SE50 motor
1985 Aero 50 w/ Dio motor: On Hold
1985 Aero 50 w/ Dio motor: On Hold
Re: 1985 honda aero piston rings.
i stand corrected
84 Aero af05e Ruckus variator, rear metro wheel, Leovince pipe ( work in process... porting , nh80 reeds intake carb)