I need tips elite sa50

Trying to get your Spree/Elite to run, or run better? Post your questions here.

Moderator: Moderator

12gauge
Spree
Spree
Posts: 118
Joined: Sat Oct 19, 2013 9:43 pm
Location: indianapolis, IN

I need tips elite sa50

Post by 12gauge »

72cc Polini corsa,v8 muffler, 24mm oko carb (reed and intake came with), eBay special variator, 9to 1 gear set, eBay special cdi, no plastics on enging or anywere else. Haven't installed head yet scared to over heat. Do u think it will can I get a couple tips to make run great Jet size? I have 115-135 up by fives. Just don't know witch to use. Plastics? Or no I cut out my whole seat bucket and put 10" radiator fan but it kills my batteri
bfowler
Elite
Elite
Posts: 509
Joined: Sun Oct 21, 2012 6:37 pm
Location: Hawaii/San Francisco

Re: I need tips elite sa50

Post by bfowler »

You could start with a 125 main and 45 pilot and see how that works. Plug chops and CHT gauge are really useful in determining jet sizes.
12gauge
Spree
Spree
Posts: 118
Joined: Sat Oct 19, 2013 9:43 pm
Location: indianapolis, IN

Re: I need tips elite sa50

Post by 12gauge »

I no there is no radiator I am useing the fan instead of the shrouds
12gauge
Spree
Spree
Posts: 118
Joined: Sat Oct 19, 2013 9:43 pm
Location: indianapolis, IN

Re: I need tips elite sa50

Post by 12gauge »

Wat exactly is a plug. Chop and how do u instal thermostat
12gauge
Spree
Spree
Posts: 118
Joined: Sat Oct 19, 2013 9:43 pm
Location: indianapolis, IN

Re: I need tips elite sa50

Post by 12gauge »

And it didn't come wit pilots. But the main is way longer than a normal main jet I haven't taken bowl off to see wats in it
12gauge
Spree
Spree
Posts: 118
Joined: Sat Oct 19, 2013 9:43 pm
Location: indianapolis, IN

Re: I need tips elite sa50

Post by 12gauge »

Nvm I no how to install cht I wasn't thinking. Wat temp should I be trying to get. With my set up
User avatar
paulpauly7
CB900F
CB900F
Posts: 1945
Joined: Tue Feb 21, 2012 6:57 pm
Location: nz

Re: I need tips elite sa50

Post by paulpauly7 »

your fan wont cool the motor.Reinstall the original engine covers and factory fan.Or say bye bye to your corsa
86 Nifty Fifty (spree)
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
bfowler
Elite
Elite
Posts: 509
Joined: Sun Oct 21, 2012 6:37 pm
Location: Hawaii/San Francisco

Re: I need tips elite sa50

Post by bfowler »

paulpauly7 wrote:your fan wont cool the motor.Reinstall the original engine covers and factory fan.Or say bye bye to your corsa
+1 on this. Fan shrouds are important!
12gauge
Spree
Spree
Posts: 118
Joined: Sat Oct 19, 2013 9:43 pm
Location: indianapolis, IN

Re: I need tips elite sa50

Post by 12gauge »

On the corsa does the ports on piston go toward exaughst or rear wheel
12gauge
Spree
Spree
Posts: 118
Joined: Sat Oct 19, 2013 9:43 pm
Location: indianapolis, IN

Re: I need tips elite sa50

Post by 12gauge »

Graphite. It did come with mains and I only ran 1/4 tank 16 to one premix in it I don't have oil pump At that time I had stock carb with 102 jet. I siezed motor because the cylinder was honed hoe ably and rings were way to loose the exhaust port ate the ring off first time I half throttled it I would put shoud back on but don't have one
12gauge
Spree
Spree
Posts: 118
Joined: Sat Oct 19, 2013 9:43 pm
Location: indianapolis, IN

Re: I need tips elite sa50

Post by 12gauge »

I rebuild motors all the time just not proformance motors I no about rings and pistons the kit. I got from chop chop was * up believe me I did it all right the cylinder was egg shaped almost the rings and piston weren't the right size. I new they weren't wen I was putting it together but I figured that's just how it had to be for some * up reason
12gauge
Spree
Spree
Posts: 118
Joined: Sat Oct 19, 2013 9:43 pm
Location: indianapolis, IN

Re: I need tips elite sa50

Post by 12gauge »

I've been trying I have I phone 4 and if won't let me upload pics says to many kig
User avatar
paulpauly7
CB900F
CB900F
Posts: 1945
Joined: Tue Feb 21, 2012 6:57 pm
Location: nz

Re: I need tips elite sa50

Post by paulpauly7 »

you shouldnt have run it
86 Nifty Fifty (spree)
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
12gauge
Spree
Spree
Posts: 118
Joined: Sat Oct 19, 2013 9:43 pm
Location: indianapolis, IN

Re: I need tips elite sa50

Post by 12gauge »

We'll now I have an amazing loo liking Polini kit I hope I can fine motor shrouds asap I WANA RIDE
User avatar
kingearwig
Spree
Spree
Posts: 207
Joined: Thu Feb 25, 2010 6:04 am

Re: I need tips elite sa50

Post by kingearwig »

upload your pics to photobucket.com then use the photobucket provided <img tag
Post Reply