AF05E Ramp Plate Thrust Washer?
Posted: Sat Jun 10, 2017 7:18 am
I've been looking in the NB50 Manual (closest I could find to my '85 UK Vision) and noticed that there's a thrust washer shown between the ramp plate and the crank shaft. I'm fairly certain that my engine didn't have one when I took the variator off, and am certain that there's not one now.
Just wondered if anyone has an AF05E without a thrust washer as standard, or if it's maybe something special that the NB50 has?
It did seem odd to me that there was no thrust washer, but didn't think very much about it until now. I read somewhere else about adding spacers behind the ramp plate to make up for longer belts, but my belt is tight enough even though it's a bit longer than standard afaik.
Thanks
Just wondered if anyone has an AF05E without a thrust washer as standard, or if it's maybe something special that the NB50 has?
It did seem odd to me that there was no thrust washer, but didn't think very much about it until now. I read somewhere else about adding spacers behind the ramp plate to make up for longer belts, but my belt is tight enough even though it's a bit longer than standard afaik.
Thanks