Crank Questions - Spree
Posted: Tue Jan 23, 2018 11:30 am
I need a bit of information regarding a Spree crank...
I am trying to figure out what bearings it needs, the manual shows two different types and only one is available anymore. I have searched and found a ton on how to remove but not much on what I need as far as replacement.
The second is does anyone know what the specs are for the nut on the crankshaft flywheel side? I have a crank that came in this bucket o'parts that doesn't have the nut, plus it has a mushroomed end from the PO hammering it out of the case... So I need two... One for the final application and the other I am thinking of splitting and using as a thread chaser. The threads nearest the internals are fine, so I figure if I can split a nut, clamp it on and walk it off I should be good...
Any help would be appreciated
Thanks!
I am trying to figure out what bearings it needs, the manual shows two different types and only one is available anymore. I have searched and found a ton on how to remove but not much on what I need as far as replacement.
The second is does anyone know what the specs are for the nut on the crankshaft flywheel side? I have a crank that came in this bucket o'parts that doesn't have the nut, plus it has a mushroomed end from the PO hammering it out of the case... So I need two... One for the final application and the other I am thinking of splitting and using as a thread chaser. The threads nearest the internals are fine, so I figure if I can split a nut, clamp it on and walk it off I should be good...
Any help would be appreciated
Thanks!