Honda Spree and Elite 50 Forums

Hey guys. I have some lateral play in the shaft that the clutch bolt to. Is this normal. I took everything apart expecting to have a bearing that the tip rides in bit theres not one. Thanks

Start by looking at the parts fiches from any of the Honda parts vendors.. here is one of several, and then select the sub assembly you are interested in:

https://www.hondapartshouse.com/oempart ... 50-a-parts

For example, to see the parts in the driven face, look at:
https://www.hondapartshouse.com/oempart ... riven-face

and the transmission at:
https://www.hondapartshouse.com/oempart ... ansmission

Yep. I got the part number from the breakdown and unavailable through Babbits... andthat part number isnt anywhere on ebay.. thanks

The parts fiche lists the generic number for that bearing as a 6202 --> 15x35x11

Here's a link for a Nachi version -- https://www.vxb.com/6202-Nachi-Bearing- ... gKPc_D_BwE

Thanks man

Hey guys. Got the bearing pressed in and a new gasket from Noiseguy. Now when i close up the case the shaft binds up.. all i can think of is gasket to thin causin case to close to much?. Any advice thanks

Greetings:

Yes the gasket thickness is an Engineered part of the assembly, and determines the end play in the shafts. Too thin and it binds on the ends. You can buy gasket material at most autoparts stores, often in different thicknesses. Alternatively, see if you can source the Honda item from a dealer or aftermarket shop. Search by part number and hope you get lucky.

Just be sure you got the bearing perfectly pressed. It's easy to miss. Freeze bearing and heat the case if in doubt.

Hey.Noiseguys gaskets are OEM thickness. The bearing wasnt Completely seated in the cover. Now its perfect.... except she wont start..