84' Spree Won't Start

Trying to get your Spree/Elite to run, or run better? Post your questions here.

Moderator: Moderator

Post Reply
gln_burke
Noob
Noob
Posts: 1
Joined: Sat Oct 09, 2021 5:31 pm

84' Spree Won't Start

Post by gln_burke »

Ladies & Gentlemen
I'm sure this topic has been beatin to death but I'm having difficulties getting this thing to start. Your input is much appreciated. Just installed a new starter. Bench tested it before installation. Starter relay is clicking when the starter button is depressed but that's it. Nothing happens other than this. What am I looking at? Faulty wiring? CDI?
Thank you in advance for your help.
User avatar
motormike
Moderator
Moderator
Posts: 5487
Joined: Wed Dec 29, 2010 10:58 pm
Location: Glasgow, KY

Re: 84' Spree Won't Start

Post by motormike »

You can rule out the CDI.
It does not have anything to do with function of the starter motor.
I defer to other members with Spree specific knowledge to help you further.
There are differences between the years of spree regarding tooth count that
could be your issue, should you have the wrong starter.
Gasket for side cover has a specific thickness...and may be a factor as well.
Bendix gear is important item in this equation...hope someone will give you some helpful advice.
Good luck...motor... :urban:
RideRed
<Gyro S><MB5><Honda Navi><Helix><Sym Wolf><Yamaha Razz><Honda CH150 Deluxe>
"Live Large - Ride Small"
User avatar
Wheelman-111
Moderator
Moderator
Posts: 11319
Joined: Wed Oct 22, 2008 5:09 pm
Location: Deepinnaharta, Texas

Re: 84' Spree Won't Start

Post by Wheelman-111 »

Greetings:

Measure battery voltage first. It should be close to 13 on the bench.
Does the engine spin freely by hand, or with a drill on the pulley nut?
Do you still have your original starter? Count the teeth on the output shafts and on the Bendix. As motormike said, all Spree starters are not created equal.
And remember, the Spree crankshaft spins Clockwise viewed from the pulley. Your starter might be trying to start it in reverse.
Wheelman-111
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
Post Reply