Trying to get your Spree/Elite to run, or run better? Post your questions here.
Moderator: Moderator
usdthrone23
Noob
Posts: 16 Joined: Mon Jul 23, 1973 10:24 am
Post
by usdthrone23 » Mon May 02, 2005 8:22 pm
i got the carb and intake off and filed the intake down and its fine but the exuast i got for free fro ma friend who had it on his razz is about a quarter inch off so im going to try to torch a piece of the back plate off were it will fit if that doesnt work ill just stick with the stock 8O
zoom
Spree
Posts: 115 Joined: Mon Jul 23, 1973 10:24 am
Post
by zoom » Wed May 04, 2005 8:26 pm
I made a mistkae . I bored out the bottom of that intake i didnt bore it much . but do yallt hink it will be fine?
vette76
CB900F
Posts: 1853 Joined: Sat Jul 31, 2004 8:00 pm
Location: rhode island
Post
by vette76 » Wed May 04, 2005 8:33 pm
as long as u didnt go past what the gasket will seal.
00' sa-50 slammed and stretched
89' elite sb, with a 99' af16, (SOLD)
87' spree (SOLD
87' mustang gt vert kenne bell, irs.
90' mustang notch turbo drag car
12' wrx
zoom
Spree
Posts: 115 Joined: Mon Jul 23, 1973 10:24 am
Post
by zoom » Wed May 04, 2005 9:43 pm
Nahh i ddint go that far.
vette76
CB900F
Posts: 1853 Joined: Sat Jul 31, 2004 8:00 pm
Location: rhode island
Post
by vette76 » Wed May 04, 2005 10:01 pm
should be fine. mine isnt the best either.its hard with a straight file.
00' sa-50 slammed and stretched
89' elite sb, with a 99' af16, (SOLD)
87' spree (SOLD
87' mustang gt vert kenne bell, irs.
90' mustang notch turbo drag car
12' wrx
zoom
Spree
Posts: 115 Joined: Mon Jul 23, 1973 10:24 am
Post
by zoom » Wed May 04, 2005 10:47 pm
After i dremeled it I used a round file.