good idea, bad idea?
Moderator: Moderator
good idea, bad idea?
would it be a smart move to machine material from the bottom of the jug where it bolts up to the crankcase, to raise the deck height of the piston and increase compression? Or is there some pitfall in doing this?
HONDA NQ50 "FIREBLADE"
its easier to deck the top.but what reason are you decking it for?
Nothing like getting stroked!
Thanks to my sponsors
Nos Energy Drinks,themopedcompany.com,nwautoevents.com,Cycle Gear
90 honda dio sp 72cc
87 elite 50 s with 86cc watercooled mini stroke
87 elite 50 race bike mhr 72cc
91 yamaha tzr 250r
Thanks to my sponsors
Nos Energy Drinks,themopedcompany.com,nwautoevents.com,Cycle Gear
90 honda dio sp 72cc
87 elite 50 s with 86cc watercooled mini stroke
87 elite 50 race bike mhr 72cc
91 yamaha tzr 250r
The reason guys used to do this on some bikes was to alter all the port timings. Frankly, unless you understand and are comfortable changing port timing, I wouldn't do that. Just knock the material off the head instead.
Admin, Hondaspree.net
Buy air filters and gaskets here (Ebay): http://stores.ebay.com/noiseguysstore
Buy air filters and gaskets here (Amazon): www.amazon.com/shops/spreepower
Buy a t-shirt here: https://teespring.com/stores/spree-powersport-products
Buy air filters and gaskets here (Ebay): http://stores.ebay.com/noiseguysstore
Buy air filters and gaskets here (Amazon): www.amazon.com/shops/spreepower
Buy a t-shirt here: https://teespring.com/stores/spree-powersport-products
Well, the head is easier to machine and cheaper to replace. I guess I don't see why you'd mess with the jug at all.
Admin, Hondaspree.net
Buy air filters and gaskets here (Ebay): http://stores.ebay.com/noiseguysstore
Buy air filters and gaskets here (Amazon): www.amazon.com/shops/spreepower
Buy a t-shirt here: https://teespring.com/stores/spree-powersport-products
Buy air filters and gaskets here (Ebay): http://stores.ebay.com/noiseguysstore
Buy air filters and gaskets here (Amazon): www.amazon.com/shops/spreepower
Buy a t-shirt here: https://teespring.com/stores/spree-powersport-products
- burnt_toast
- Veteran OG
- Posts: 3592
- Joined: Sat Jul 31, 2004 8:00 pm
- Location: Atlanta, GA
The port timing on these is very conservitive. Machining the bottom of the cylinder will lower the ports reducing performance. Some actually spacer up the cylinder to raise the ports. The easy answer is mill the head. If you want to get fancy spacer up the cylinder then cut down the top of the cylinder the amount of the spacer. Make sure you understand what the ports are doing and the port angles before and after.
keithw
keithw
Honda Pal (Speed-o-scooter) JDM Spree with varator trans.
Honda Spree, 1985.
Another Honda Pal
Let's give it a try, how hard could it be?
Honda Spree, 1985.
Another Honda Pal
Let's give it a try, how hard could it be?