head turning

[portets]

just got my tazland kit.

so when i go to get my head turned, what dimensions do i use? i know it's 44mm in diameter, but how deep do i have it cut? 0.020 inches like the factory step is? at least i know it's 0.020 inches deep on the 85..... but i have an 87'. any difference there?

i'm looking for a compression ratio between 8.5:1 and 9.5:1. 8:1 is my minimum, and 10:1 is max.

sorry if i'm bombarding you with math, i just want an estimate though.
thanks!

[noiseguy]

Personally, I'd just just the .020" off the head *if it will clear*. This will make it flat.

Otherwise you'll need to ask the seller. I think the idea would be to remove .020" from a band around the edge.

[toboggan]

I do it for 20$ and i pay for return shipping too.

[bradthreee]

I do it for 20$ and i pay for return shipping too.

Killer deal

[portets]

cool. i may already have someone to do it, but if he can't i might just send you a pm.

so, .020 deep and 44mm wide? okay

[toboggan]

yep. 20$ and we pay for return shipping

[Kenny_McCormic]

I would bore level to the combustion chamber surface.

[maddog]

well i suck at math so here is my formula, big bore- gear ratio= "big boom" also i told my co-workers last week that GM/ saturn should go and now its gone i feel it....

[zapwalker]

yep. 20$ and we pay for return shipping

if i pay pal the money to you could i get the kit shipped right to you then you could send it to me when the head it tuned?