This is a step by step on how to cut down an se50 mount to fit an af16E or variated AF05E on a spree.
This is an uncut SE50 mount
Here is the uncut se50 mount next to a stock spree mount.
A tiny bit needs to be cut off the right side of the mount. Just enough that the middle and the outside are flush wth one another.
Next about 11mm needs to be taken off the left side of the mount. (Measure the original spree mount for an exact amout to be taken off)
Now cut off these two bits from the spree.
And the new SE50 mount should fit perfectly
If you are mounting a af05e engine you are done. If you are going with an AF16E then....
Drill out the back half of the mount to 10mm
Any questions?
SE50 mount for a dio swap
Moderator: Moderator
- Trafficjamz
- CBR1000RR
- Posts: 5353
- Joined: Tue Jul 14, 2009 7:53 pm
- Location: Eastlake, MI
- Contact:
SE50 mount for a dio swap
new best 1/8th mile time 9.647 seconds @67.155 mph 310lbs total weight
Re: SE50 mount for a dio swap
I use the metal sleeves on your kicker case to avoid drilling out the back half to 10mm
In 2040 they say we're going away
We could never let them control
Hawaiian man, take back your hawaiian land
We could never let them control
Hawaiian man, take back your hawaiian land
- Trafficjamz
- CBR1000RR
- Posts: 5353
- Joined: Tue Jul 14, 2009 7:53 pm
- Location: Eastlake, MI
- Contact:
Re: SE50 mount for a dio swap
That is a good idea808BMW wrote:I use the metal sleeves on your kicker case to avoid drilling out the back half to 10mm
new best 1/8th mile time 9.647 seconds @67.155 mph 310lbs total weight
- bradthreee
- Board Supporter
- Posts: 2142
- Joined: Tue Sep 12, 2006 4:20 pm
- Location: MARS...
- Trafficjamz
- CBR1000RR
- Posts: 5353
- Joined: Tue Jul 14, 2009 7:53 pm
- Location: Eastlake, MI
- Contact:
Re: SE50 mount for a dio swap
Looks strong. Maybe a little overkill.bradthreee wrote:Maybe I went overboard, but this is what I did:
new best 1/8th mile time 9.647 seconds @67.155 mph 310lbs total weight