Head shaving suggestions. Two different engines...
Moderator: Moderator
Head shaving suggestions. Two different engines...
I just picked up a 1990 SB50P and bought the tazz BBK and intake / Carb kit. Since I have to get the head milled for the bigger bore I figured I would get the head shaved too. Also I am going ti bring in the head for my Malossi SE50 kit in and have it shaved too. The SE50 is at 110 psi right now. What should I have shaved off these heads?
- SuprasNsprees
- Elite
- Posts: 564
- Joined: Mon Jun 20, 2011 2:05 pm
- Location: saint louis
- Contact:
Re: Head shaving suggestions. Two different engines...
I took 0.015" off and wound-up with 129psi. my spree runs very well after switching to the coldest plug and a 93/110 gas mix
'86 Honda Spree : taz stage3 w/ mild porting, head milled 0.015", and pulley mod. 2k+ mies on kit
'80 Puch Magnum MKII
'78 Maxi Newport. Polini 64cc case matched, hi comp head, Rito alum crank, delorto 21mm race, etc.
'78 PA50 Hobbit
'80 Puch Magnum MKII
'78 Maxi Newport. Polini 64cc case matched, hi comp head, Rito alum crank, delorto 21mm race, etc.
'78 PA50 Hobbit