Page 1 of 1
belts
Posted: Fri Nov 04, 2016 6:33 am
by GuavaJam
Any recommendations? I ran a big teeth stock sym belt on my 72 dd, I hear guys have preferences for big teeth/small. What's the diff in performance, durability? Thanks
Re: belts
Posted: Fri Nov 04, 2016 11:25 am
by Wheelman-111
Greetings:
Malossi makes a good belt for both the S and the ZX transmissions. Graphie has/can get them.
Re: belts
Posted: Fri Nov 04, 2016 4:33 pm
by Meloshameless
I run the malossi belts on my stock elite pulley and my zx pulley, spacing the drive face was required and spacing the tranny cover with some washers. Graphie has the boss spacers too.
Re: belts
Posted: Sat Nov 05, 2016 5:47 am
by GuavaJam
So why is the malossi better? How much does it typically cost? Thx
Re: belts
Posted: Sat Nov 05, 2016 2:14 pm
by Wheelman-111
Greetings:
I found it feels like it grips the pulleys better, believe it or not. My Flash9 has the ZX rear pulley and uses the 18mm version. It's somewhere between the standard 654mm and the 669mm ZX belts, making it ride a bit higher (further from center) on the rear pulley, perhaps good for a little lower gearing and faster take-off. With the oversized 97mm Malossi front pulley, it can also extend the Overdrive at top speed, for a little higher peak speed - over-range at both ends, perfect.
This guy has a new one for $15. If I didn't already have a spare, I'd jump on it.