2000 Elite SA50P mild build
Posted: Thu Sep 13, 2018 12:25 am
Looking for everyone's suggestions on a mild build for my SA50P.
I would like to do a gear swap and pull around 45-50 mph on my stock bore if possible. Scoot has about 5000 miles on it now, I plan to hone it out and replace rings before doing this build.
It is currently de-restricted, has lighter roller weights, and heavier springs in the clutch.
I figure at least I will need:
Gears: 15x42 or 16x42?
Variator: stock variator is grooved up pretty bad.
Roller weights
New contra spring: about 15-20% stiffer?
Carb & Intake Upgrade: bigger jets for stock carb or new carb?
I'm not looking to break the bank on this project, otherwise I'd be doing a BBK. Just looking for some reliable power that will be able to keep up with new gears.
Thanks in advance!
I would like to do a gear swap and pull around 45-50 mph on my stock bore if possible. Scoot has about 5000 miles on it now, I plan to hone it out and replace rings before doing this build.
It is currently de-restricted, has lighter roller weights, and heavier springs in the clutch.
I figure at least I will need:
Gears: 15x42 or 16x42?
Variator: stock variator is grooved up pretty bad.
Roller weights
New contra spring: about 15-20% stiffer?
Carb & Intake Upgrade: bigger jets for stock carb or new carb?
I'm not looking to break the bank on this project, otherwise I'd be doing a BBK. Just looking for some reliable power that will be able to keep up with new gears.
Thanks in advance!