Corsa cylinder wall imperfections

Does your Spree/Elite already run great, and you're trying to make it quicker/faster? Need a monster motor swap? Discuss your ideas here.

Moderator: Moderator

Post Reply
User avatar
Posts: 218
Joined: Sun Jun 02, 2013 8:23 pm
Location: United States

Corsa cylinder wall imperfections

Post by whitey »

I just bought two corsa cylinders, one from Treatland and one from SSS. Both have the same markings below the ports. It looks like boring drill lines that didn’t get honed out. I’ve never seen imperfections in a bore except porosity on nikasil bores. Is this normal for corsa bores? The marks are below the ports but the rings still land there at BDC. They are not raised so maybe they would not damage the rings and maybe actually help hold more oil where needed?

I’ll try to add photos later
01 Honda Elite S 120cc Taida H20
78 Honda Hobbit Athena
78 Honda Express/Hobbit Stage6/Athena LC 70
00 Gilera Runner PM Tuning 172
09 Aprillia SR50 Malossi Team MHR
81 Puch ZA50 Polini
71 CT70 Blue
79 Z50 Red
Post Reply