help needed

deathwish · Post by **deathwish** » Sat Jul 30, 2005 11:57 am

i've been reading around this forum and i found soom great ways to increase performance of my spree, i have opened up the intake already but im sorta stuck on what to do on the pully and on the head

, can any one help?

vette76 · Post by **vette76** » Sat Jul 30, 2005 12:28 pm

if u dont have the right tools then dont mess with the head. the pullet can be done with even a grinder. on the inner pulley just take a little off of the middle piece so the pulley halfs are a little closer. keep in mind that you will lose low end power.

MYSTERE1 · Post by **MYSTERE1** » Sat Jul 30, 2005 4:58 pm

after you mod the pully you have to use washers to keep everything elined.

MySpree · Post by **MySpree** » Sat Jul 30, 2005 5:24 pm

wit pully mod i think i missed this one and which pully the inner pully? 8O

deathwish · Post by **deathwish** » Sat Jul 30, 2005 9:10 pm

will i need a smaller belt if i mod the pully?

MYSTERE1 · Post by **MYSTERE1** » Sun Jul 31, 2005 11:35 pm

yah, about 1" smaller in diameter. with the stock belt you will have to push it to get it to move off the line. it just slips too much. but try it and see for your self.

darat · Post by **darat** » Mon Aug 01, 2005 12:28 am

can i put the varitor on the spree. i have a extra one because i got a complete kit when i order my high speed kit. i was J/W

vette76 · Post by **vette76** » Mon Aug 01, 2005 1:05 am

1st of all u should not need a new belt. the clutch is spring loaded to keep tension on the belt. the other thing is a variator will not fit the sprees crank. noiseguy and i have already talked aboout it and tried it and its not even close to fitting or lining up.sorry!