Custom expansion chamber exhaust for Spree

This is the repository for hop-ups and mods for Elite and Spree. Look here for information on exhausts, porting, cylinders, intakes, and suspension mods.

Moderator: FAQ Moderator

Locked
User avatar
noiseguy
Site Admin
Site Admin
Posts: 4419
Joined: Sat Jul 31, 2004 8:00 pm
Location: South Florida
Contact:

Custom expansion chamber exhaust for Spree

Post by noiseguy »

The below is a picture of the Highway Speed Pipe that I used to build and sell. This is made from a pocketbike pipe fitted to a stock 19mm Spree downpipe.

Image

Note the correct length of downpipe for this pipe to match the original, at about 9" in length. Also note the attachment to the original exhaust mounting; this gets the pipe low enough to fit with panels. This pipe is tuned for around 8-9K RPM.

Low end power is reduced, with speed picking up around 20 MPH, where it takes off. Previously with a shortened stock pipe, I was hitting around 28 MPH. Now I can do 33, albeit it takes longer. Retuning the fixed ratio transmission helps balance launch with speed, as always.

Keep in mind, this is all done with the stock airbox and #65 jet. I haven't found that rejetting is required with this modification.
Last edited by noiseguy on Fri Mar 10, 2006 10:57 am, edited 1 time in total.
Admin, Hondaspree.net

Buy air filters and gaskets here (Ebay): http://stores.ebay.com/noiseguysstore
Buy air filters and gaskets here (Amazon): www.amazon.com/shops/spreepower
Buy a t-shirt here: https://teespring.com/stores/spree-powersport-products
Locked