1st time building a H. Minarelli...Tips or Advice???

Need help with your non-Honda scooter? Yamaha, etc? Post here!

Moderator: Moderator

Post Reply
User avatar
bradthreee
Board Supporter
Board Supporter
Posts: 2142
Joined: Tue Sep 12, 2006 4:20 pm
Location: MARS...

1st time building a H. Minarelli...Tips or Advice???

Post by bradthreee »

I've finally got enough parts to start on my horizontal minarelli build. Here is a list of stuff I have so far:

Stage6 Race BBK
Stage6 HPC crank
Stage6 bearings
Stage6 V-Force Reeds
OKO intake manifold
Mikuni TM24 Carb
Malossi Multivar
Hebo Red center clutch spring
Malossi MHR replica Pipe
Stage6 Belt
Kundo Clutch bell
Stage6 Clutch

I plan on doing the install of everything myself and feel pretty confident with the bolt on's, but am a little scared of splitting the cases. I will get over my fear and get her done. Is there anything I should do while I'm inside the engine? Besides a tusk crank tool and flywheel puller, any other specialty tools needed? I plan on doing the heat/freeze method during the install of the crank. What jets should I try to start with for initial break-in? How about rollers? I was told to run 21 grams, sound good?

Any other tips or tricks to help me do things smoothly? Any help is greatly appreciated.

Thanks,

Brad
veedubh20
CB900F
CB900F
Posts: 2052
Joined: Sat Dec 31, 2005 7:00 pm
Location: Honolulu paradise island

Re: 1st time building a H. Minarelli...Tips or Advice???

Post by veedubh20 »

Need special tool to split case.. 2 long bolts steering puller, that has a bolt in a middle can push crankshaft, then block will be split.

Here is the link how to split block.
http://49ccscoot.com/disass.html

stage6 single ring?

some bore kit are bolt on or not, Base gasket need to match case transfer/boost port on a block case air/fuel tunnel onto cylinder jug

Jet kits go buy vary size jetting pack.. p-jet and main jet.

Ran good syntek 2 stroke oil. 32:1 premix.
veedubh20
CB900F
CB900F
Posts: 2052
Joined: Sat Dec 31, 2005 7:00 pm
Location: Honolulu paradise island

Re: 1st time building a H. Minarelli...Tips or Advice???

Post by veedubh20 »

Post Reply