Rear pulley question

Need help with your non-Honda scooter? Yamaha, etc? Post here!

Moderator: Moderator

Post Reply
GuavaJam
Spree
Spree
Posts: 104
Joined: Wed May 22, 2013 4:54 pm
Location: usa

Rear pulley question

Post by GuavaJam » Thu Dec 10, 2015 2:11 am

Recently replaced: weights (7.0 g), stock DD belt, Keli medium clutch, 1500 clutch springs, and 1500contra. I'm so dumb (still newbie) that I didn't bother to check the rear pulley. Bike seems to be running good, although 9 yrs old 2006 mild 66cc daily driver DD50, what exactly needs to be done to keep rear pulley running good? Or is it time to just replace it? Also using Keli vario w/Daytona ramp. Thanks.

GuavaJam
Spree
Spree
Posts: 104
Joined: Wed May 22, 2013 4:54 pm
Location: usa

Re: Rear pulley question

Post by GuavaJam » Fri Dec 11, 2015 3:02 am

I'm referring specifically to the torque driver. Thanks.

User avatar
bonesv
Moderator
Moderator
Posts: 1699
Joined: Sun Jun 26, 2011 2:00 pm
Location: Florida

Re: Rear pulley question

Post by bonesv » Fri Dec 11, 2015 8:10 am

You can dis-assemble, clean and re-grease. Check the seals. inspect for wear, but usually just clean and re-grease is what I do. It's easy to cross-thread the large nut that holds the clutch and torque spring on so be careful. The torque spring is worn out when it up-shifts too soon. Just replace it.
Honda Elite SR
Honda Dio-Elite SR
Honda Elite LX
Pineapplegti wrote:Ruckus mods should never carry over to vintage scooters......it just isn't kosher.

Post Reply