Ok, I am almost ready to fire up the spree after installing a new piston + cylinder..
When putting the bike back together, I noticed the throttle cable is missing a small retainer clip near the throttle valve area. The retainer is pictured on pg 4-3 of the spree service manual.
I notice the throttle action is very limited, it seems hard to turn and works over a very limited range.
What does this retainer do - can I get away without it??
Throttle cable is missing the retainer
Moderator: Moderator
Throttle cable is missing the retainer
Scooter-less
turn the throttle cylinder around 180 deg. until it drops in further. that will fix the throttle issue. with out a clip the pin can not do its job right. is it loose? if not you might be fine.
00' sa-50 slammed and stretched
89' elite sb, with a 99' af16, (SOLD)
87' spree (SOLD
87' mustang gt vert kenne bell, irs.
90' mustang notch turbo drag car
12' wrx
89' elite sb, with a 99' af16, (SOLD)
87' spree (SOLD
87' mustang gt vert kenne bell, irs.
90' mustang notch turbo drag car
12' wrx