Thanks for giving me my props for the Band-Aid "solution". Be advised that Taiwanese Band-Aids are reportedly "rubbish".
![wink :wink:](./images/smilies/icon_e_wink.gif)
![geekdance :geekdance:](./images/smilies/icon_geekdance.gif)
Moderator: Moderator
tazland001 wrote:If the rings are good I have a 50mm RIK piston with nothing else. You can have it. PM me. I am suprised you did not PM me in the first place.
Taz
Why do this?evilone wrote:You could remove them reed springs, that'll take a little tension off the reed petals.
bump that pilot to a 55 or 58 at lease.with the 9.8to1 gears run the 90/90 tire. for your drag setup up the compression and run race gas c12. your 60ft times will get way better.Trafficjamz wrote:Got the piston from taz. Thanks again.
This Build is back in bussiness.
This engine is going to go on the superman drag bike.
The main jet is now 150 and the pilot is 50 on the 30mm OKO carb.
The gears are 9.8:1 and the rear tire is going to be a 80/90
2k grab springs 1.5k centerspring and I can't remember the weights
Prodigy clutch, clutch bell,and variator.
Dragstrip is friday night.....I will post results.
I have switched to a 90/90 tirebakaracer wrote: bump that pilot to a 55 or 58 at lease.with the 9.8to1 gears run the 90/90 tire. for your drag setup up the compression and run race gas c12. your 60ft times will get way better.
Snowman94 wrote:Traffic, I am building up something similiar, and i am going to drag race by the end of July as a goal. By the looks of that GPS, you were rolling out!
MopedMan84 wrote:how fast is it>?