Hi all.
I'm doing a Ruckus GET engine swap on my 86' Spree and had a question about the starter switch wiring. I am using the original spree switch housing but running into an issue of the ignition coil not firing. The tail light will dim but there is no current coming from the ignition coil wires that connect to the coil itself. There is resistance on the ignition coil, so I am assuming everything is fine there.
The issue I may be running into is the correct way to wire the three wires from the spree switch housing and the 4 original wires that the Ruckus started switch had.
I'm stumped as I don't know what to do from here.
Spree Controls with Ruckus ECU
Moderator: Moderator
Re: Spree Controls with Ruckus ECU
You may have to be patient. This is a 2-stroke forum.
Honda Elite SR
Honda Elite-Dio ZX
Dio ZX Headlight/Disc Brake Mod: http://hondaspree.net/phpBB3/viewtopic.php?t=30861
Honda Elite-Dio ZX
Dio ZX Headlight/Disc Brake Mod: http://hondaspree.net/phpBB3/viewtopic.php?t=30861
Re: Spree Controls with Ruckus ECU
I understand thank you
I'm about to throw in the wrench. The ignition switch, when turned off, pops the fuse now. So I'm at wits end.
I'm about to throw in the wrench. The ignition switch, when turned off, pops the fuse now. So I'm at wits end.